Search results

calshawed from AF and USA and tagged seabee. as nature intended it lol

it is Electric fuel swap time

isn't there reinforcment bar installed between the tranny and the tranfer case ,on top? also have made sure or spline count ?

I need two

1990 and above 6.2L and 1994 6.5L engines have the following new and revised parts: *Cylinder Heads. The 1990 cylinder heads have been revised to meet 1990 emissions standards. Precombustion Valves. The 1990 engine is equipped with reverse throat precombustion chambers. Exhaust Valves. The 1990...

Got to love those POU racks lol, four gpm is that a single pass?

I have a trailer I am an hour or so north off I-64 from the morehead exit

I had an Iveco truck with a 727 trany in it , it had 332 diesel in it

Thanks guys, I was about to install a couple of these FM 100 filters one with electric fuel heater the other with the fuel return manifold heater. I never consider the amp load on these...

probley a GM-1 with mech master

spit balling here, maybe you air bubble in the system? it is common in higher pressure system ie bmw & merc. The heater core seems to be highest point in the system. Therefore causeing and air lock in the core.

300 ford imho

You would think a Rosa Master I.P for oliver tractors or the 8.2 had one?might be a place to start.

I am doing the same eng./tranny swap with a divorced T case in my M37

fuel pump?just spitballing, diesel gets thick this time year fuel heater in the filter base could be kaput?

roof rack on top

FYI I bought one last week with a good body runs only moves in 1 and reverse for 5 bills and it a 12 volt conver. and missing pass window.

yes you correct, I have 6.2 out of school bus in my 1009 the one I got off 6.5 and it are the I used the one with motor orginally. please note it tuff sob to fish that crossover tube in

here is thermostat and switch this one 160- to 210F yet more electric to go wrong on cucv

I asked this question the other day. A 6.5 turbo oil cooler is nothing but a stand alone direct air cooler, similar to a after market tranny cooler. I figured it all coming from the same heat source. The 6.5 rad. may be more effiecient than the 6.2. About the electric fans, I think you have to...