Search results

https://www.easternsurplus.net/PartDetails/3955/Transfer-Case-Indicator-Data-Plate

Acquired an old sling rope to use for recovery. Usually for someone else's follies...

Ah...that makes sense. Thanks!

No. No markings other than CARC. Sent from my SM-N910P using Tapatalk

What is this specifically? I scrolled the parts catalogs till I went blank...

Finally took it out for a proper shakedown. Came right to the edge of getting stuck...it took some doing though. Beastly machine stock.

They had minimal movement. They weren't touching, but real close. I swapped out the new short for the original long stud isolators. I installed the old washers behind the isolators to give them a smidge more clearance Way better thread engagement and housing clearance now. Thanks for the...

Yes, but it has the brakes and gravitational presence(curb weight) of a half ton truck

Reading this made me revisit my Short stud issue with my Trucklite LEDs. I dug out my old headlight buckets and harvested the isolators. I will move the beast outside in the morning to see if I can effect an isolator transplant.

finally took it offroad and ran the transfer case through the ranges. Real hard to shift even using all my slow roll in neutral skills. It shifts, but right at that "somethings gonna break" effort. I cleaned an lubed the shifters and pivot points of the linkages last week so those are good to go.

Cleaned up the battery cables and installed new clamps Installed the keyed ignition switch Upgraded to the A2 steering wheel Retrofitted Civilian wiper blades.

Start from the problem and work toward the battery. Replace the bulb with a known good unit to eliminate the easiest first, Then inspect and clean the socket contacts and socket barrel itself as its the ground path, then look for the power and ground wires and where they fasten and clean that...

Scored a complete Luverne Brush guard. With the mounts, rubbers, spring cables, and bridge plate. Local, too...No shipping!!!

I wonder if thats what I got going on now...It was a knuckle+ low when I changed fluid. Then it started the leak. There is evidence that it has been happening in the past.

today's project...clean out the shifter assembly and install reverse switch

I use fine sand paper, red scotchbrite, steel wool, acetone. Slowly work the layers away. the acetone just cleans away the sanding dust.

I was comparing the dimensions of the Gama Goat's cargo box...88"long x 81"wide to my 2 man m998...87"long x 83" wide. You could probably get one to fit with some customizing of the bows. Like a short 2 man cargo top

I'm planning to replace the wood with fiberglass. The wood just seems out of place on these trucks. To me, the fiberglass boards are synonymous with the HMMWV.

Bingo...I'll bet thats it.

Seems like the dimensions are way off for the HMMWV top. The side curtains would be 4 foot long and the top would be like 12 foot and it should be 7 foot wide. I wonder what they are from.