Search results

Yeah, until I settle on a tank build it's going to ground. I'll only have gray water discharge with a 5 gal tank (won't settle on location until I do my underbed boxes on the sides of the rig). The toilet will be a Laveo, so no black tank (but for now I just have a portable camp crapper for...

Water heater is cradled and strapped. Ain't goin' no where....

My moto

Thanks. Cheaper than my making one. :)

Yep, everything (including the heater) is above the drain port on the tank and drain. And at the back of the truck (at the entry/deck) I have a cold water outlet with one of those little outside shower head/coiled hose (for washing sand off dawg and feet). It's standard hose thread and I'm...

Small pile of stuff that's been in my living room for the past several years. LOL

Yeah. But I need to sort out where. My assumption is from the ass-end of the line back towards the tanks/drain. And I need to incorporate an air fitting.

Also, I "think" that I have everything I need to make sure the system drains for winterization (I hear that people actually have to do that north of San Antonio). The tank drain is below all the line runs, below the heater and the drinking filter system. I have tiny in-line cutoff valves for...

Yep, I saw a slick Kodiak ambo conversion that had it in his tankless setup. I thought about it for the sink, but the heater is directly under the sink so there's not enough wasted running to hot to worry about there The shower run is only ~10' of line and I'm installing a bypass valve that...

The heater is secured with an internal frame that's attached to the wall via rivnuts. Tomorrow I'll build the cradle/base the heater sits on. It will then be held in place with banding strap and a layer of 1/8"neoprene rubber (same way the water tank will be secured). I have two small vents...

As I said, es agua caliente (propane hot water heater) :)

es agua caliente

Thanks. Dragonbyte's forum search engine was returning nothing of value in here. And the only things I could find on the web were Cummins discussions about using the diagnostic tools/software to change the actual shift points. And of course you can't locate anyting in the TM unless you...

What's the keypad sequence/procedure to force the transmission to "relearn"? A guy was asking on FB and I thought I had it in my notes, but I don't. I've searched high and low on the Internet and can't find it. Cruising thru the TM's has given me a headache. I give up, thus asking here....

It's super simple, really.

So much THIS ^ Even with my A1R and 260a alt, I'm only running dual batteries (the other pair is for the habitat and charge via shore power). Now if your truck is a daily driver operating above the arctic circle, then the extra cranking amps are needed. But S&S really screwed the design...

Honestly, I think these controllers are extremely easy to fry. It's why I'll be looking to an alternative to replace mine.

Looks a little dull to me. Needs some knob polishing. Put one of the dancers to work on that task.... :)