Search results

Is this truck sort of a holy grail of 10 tons? Did the PO know what they had? On another note it would look good with a piece of towed Artillery behind it....

My truck has two air filters because I'm planning to install a turbo in the near future and that turbo sits in the spot where the heater should be. Because the heater will have to be relocated to the driver side I decided to give myself a challenge and put the heater in the driver side air...

Not sure if this is the same but it's an M60 on a mule that I saw at a show:

I replaced the 2 stickers on the door and also the ignition data plate and the pre-heater data plate.

It takes 30 minutes of idling to get my M813 up to 120°

I got some paint mask stencils from Rick Larson and added the old unit ID numbers to the front bumper using 3" tall characters.

Finally got a short video of the jake brakes in action on both LO and HI. This was in 5th gear between 40-45 mph.

Today I drilled and tapped the stock manifold and installed the temp probe. The interrupted thread NPT tap (the black one) made easy work of the cast iron and it all went off without a hitch. The wiring is hooked up and I connected power to the gauge - now all that is left is taking it for a...

Truck looks really straight- very nice! As far as being complete goes, is it missing anything?

Sweet! So is this the only M125 with the V8-300? I've heard of M123s with this engine.

There was finally a lull in the breeze long enough to get some stenciling done.

That's quite the spread!

It looks like I could make you a gauge pod for $48. The extra setup cost for loading the special roller dies into the press brake adds a little more than I was initially thinking.

I haven't messed with them yet but from what I've read most of the manifolds are mounted upside down so they could be the same as you're seeing just upside down. Here is a good thread with lots of turbo installs of different configurations: M809 turbo installs Here is a compilation of the...

I'd say about 5 years old or more. I remember seeing active Ebay listings for those about that long ago. Edit: the tan 4x4 was from May 2013 according to their Facebook page.

Here are some over-priced FTF Tech 813s next to a Porsche 911... On 1600-20s On 1600-20s On 1400-20s

One last add-on that I just finished (sorry it's not a video of jakes operating) The reservoir tank lost its support bracket when the lift hook got removed for clearance so I finally got a new bracket made up to take its place. The new bracket is a slimmer, ambidextrous, 10 gauge version of...

Not an M813 but just for fun. That's a real car on the back.

I took my kids in the 5 ton to their school's end of year parade to say farewell to their teachers!