Search results

. Yes Sir. T-Lock And this is one version (below) of the Trim Lok tool to install the rubber sealing part into the gasket that runs around your window or windshield .

. Absolutely. There are FLA's and TLA's - Four Letter Acronyms and Three Letter Acronyms - and then there are others that are just arbitrary.

. Like @GeneralDisorder said... You need to start replacing the wires. Even if you decide to use "liquid electrical tape" on the outside of the bundle - all you need is a big bump - and some piece of wire falls out from between another wire, and poof. Up in Smoke!

Okay! Well then, you mentioned "The tank in the armor is a nitrogen tank/valve." so I guess you should be able to fire that baby up! Even solves my question about over-charging the starter with several thousand pounds vs a hundred. Any chance you could shoot us a picture or two? Maybe even...

. Welcome to the Outfit! Good looking truck too... Be sure to download the TM's (Technical Manuals) for your new beast. There are parts books, troubleshooting guides and the "Dash 10" operators manual. Be sure to read that one. It will keep you from frying your glowplugs if you follow the...

. My best guess is that it will turn over and in another turn or two, the nitrogen will leave through the exhaust - bringing your air/fuel mixture to more reasonable rates. Air is 78% Nitrogen, therefore if you accidentally mix pure nitrogen with air, nothing bad will happen.

. I would be concerned. If you have a full tank of nitrogen - and no regulator - and you put 3000 pounds into a hundred pound air line you might have a really bad day.

. Wow! And the fuel tank sitting right there... That could have made a bad day into a REALLY bad day!

. Welcome to the Outfit! So, it might be useful for you to download the TM's (Technical Manuals) for your truck. Problem determination can be made easy with those books. Flow charts and all... Gotta ask, what do you need more than the Cat 3116 being the motor? I imagine the dealer could...

. Welcome to the Outfit! Yes indeed. Now you wait... Then one day you go pick it up, or it magically arrives on a trailer.

. Neat little guy... Not even as tall as the fenders on your truck! That pic might be particularly nice when he gets older.

. I understand that the latch on the cab is different between the soft doors and X doors. Can't swear to it, but I know I have read it here before...

. @ODAddict

. Small Block Chevy with a TH350 or TH400 will fit. Will require drive shaft modifications. Might cost less to find a 230 though...

. Dale doesn't have enough posts to be able to PM you. Possibly you could PM him?

. Welcome to the Outfit! Yeah, for the most part I have always paid for delivery after the vehicle arrives. Doesn't matter though. You have done it and now you are on edge until it shows up... Hope everything works out for you. You are way ahead of most folks who buy then question - rather...

. I have two chargers. Just dumb luck... Before that, I would clip a charger onto one battery - charge it for several hours, then swap to the second battery and do the same. It might also be beneficial to know that your batteries are good. Here in the states, you can drop by Auto Zone or one...

. Wow! You done good... Having a picture of where it was before could be helpful. I would install it - matching the marks together - and if you need a little adjustment then go for it. I doubt the timing chain has anything to do with the IP advance.

. Hi Ken, I'm hoping to get a nice shot of the front of the building to use on a book cover. Nothing special other than that... No crunch to get it quickly. Maybe in a week or so? @juanprado , I could use a pic of the lead up to the building - possibly the front of the building. AND if...

. Just be sure to put a fuse or circuit breaker on the air compressor... .