Search results

Looks good and free so push the shut down cable in to the run position and replace the shut down cover.

Filters, pressures, boost then injectors all covered in the trouble shooting.https://www.steelsoldiers.com/showthread.php?116454-LDS465-1-Multifuel-Engine-Troubleshooting-Manual

I am wondering if you collar is getting stuck / sticky on the plunger. When we get ready to install a Head when we turn it up side down the sleeve must be free enough to slide down by its self. Then turning it up right and it falls back down.

Your welcome glad you got it back together.

Yea nasty stuff think it even got the Dinosaurs stuck.

Turn on the in tank pump. Yea you will have to do the fuel filters and check the canisters for rust.

Asphaltenes. http://www.lcbamarketing.com/asphaltenes_and_fuel_filter_plug.htm

Yea Orren had the best idea when we were talking about it a electric fuel solenoid wired to the master. Easy because of the Synflex plastic tubing.

After you remove the fuel control and it has sat in something see if it has freed up. If not your going to have to pull the fuel control apart. The tab and the shaft are splined and that is what we want to watch very close as to the orientation of the alinement or number of degrees it sit at and...

I have had one that was so stuck even after I removed it it would no come apart with a hammer. Remove it and mix 50 50 ATF and acetone and let it sit for a couple of days in a jar of the mix then see if you can disasemble it and clean it. Be very careful to watch the way it is put together and...

Anyone do small time sand blasting or storage tank work? I have a new Bullard ambient air compressor feeds two helmets.

I will just stick with a diesel oil known to have high zinc and I use Blackstone labs. Additives made for increasing zinc are out there if your oil falls a little short. Use break in oil on new flat tappet engines plus I have my medical card so pass the good stuff my way.

Well the good thing looks like someone left the shut down cable pulled out like they should. The fuel control is stuck in the shut off position and if someone were to start it it would have gone to WOT. Your going to have to cut the safety wire remove the fuel control and see about getting free...

If it is still visible there is a number on the side of the button.

Maybe he is just proving a point that he can Homestead at the court house. Greg sounds like you have a place to live if you want to move.https://www.seattletimes.com/seattle-news/homeless/judge-rules-seattle-homeless-mans-truck-is-a-home/

Nice. Yea if nothing is wrong with the lower unit then just rebuild or different head. Wonder if it uses the same timing button? Still bet he could get a new button and clip from Ambac. Also if the plunger and drive key is ok wonder if just removing all port plugs and a good cleaning then button...

Disgrace he called it a Deuce and a half.

Yep it has a locked child / snake proof cage and they just let Skyler get in the pic for a quick snap shot then picked up the monster and put it away. You could also leave the master on for a couple of mins. and get the fuel moving through the IP plus bleed the system at the bleed screw at the...

Guess if your just looking for lubricity then two stroke. Looking for cetane booster, fuel system cleaner and stablizer then we just pay more for the product that was designed to do that job. If you believe what we read then Opti lube is higher then two stroke for lubricity.

Five footer not bad but how bout this one. This is my Sons girlfriend snake and daughter. Shut down cable looks ok too me.