Search results

The self etching primer mentioned above is SUPER important, otherwise paint will peel off. Available in rattle cans at your hardware store.

Read pdf: https://www.steelsoldiers.com/threads/2011-997-wont-shift.189327/#post-2225152

Got mine from 86humv today and they are spectacular.

Use this: https://www.southwire.com/calculator-vdrop

Thanks for taking the time to post this. I don't think San Diego gets much rain but it only takes once to fill an engine with water when the exhaust outlet it pointing at the sky. Once that happens, the engine is scrap value only.

There is a fitting in the oil gallery behind the fuel pump that feeds the oil filter.

White rectangular decal on valve cover tells me GEP.

Rod Hall is just a nitrogen charged shock in addition to the stock one. No additional travel. Spring rate is unchanged I believe. The GMVs are set up for very heavy ammunition and fuel loads. SEE POST#13. above is incorrect.

Paralleled 30's. They will act as redundant power supplies and if one fails during high production, you can send those people home.

Yes. Although General Motors was a little wrong here. OP has a shelter carrier CUCV II. With the original GM CUCVs, the shelter carrier is called a M1028. So technically GM should have called this one a M1028A4 because A1, A2 and A3 were already assigned to versions of the older trucks.

OP does have a CUCV, a CUCV II or CUCV 2 to be specific. Nobody has posted the GM factory wiring diagram for the CUCV II to include the under dash changes. There is a diagram for the charging circuit that a member has drawn up and posted.

No 24 to 115 converter. What is on the wall in the van is a 115 to 24 converter. So you can run the 24 volt lights with the engine off from 115 volt shore power.

The big plugs are to feed the van circuits from a remote power source. Not 24 volts

There is a connector sticking out of the van that is about as big around as your thumb with wires coming out of it, that leads to the 24 volt power on the chassis. Trace it out and see why no 24 volts is getting back there.

You have the cable right there. Don't you see it? Aint no cable that goes from the 24 volt slave receptacle on the cab to the 110 volt input on the van.

Wish that was true

No switch and no reverse lights.

Couple points to help you. Post questions about your deuce in the deuce forum. You have a shop van, either a M109 or M185. You need Harness Assy shop van exterior P/N 10937059.

You posted in wrong forum. bat box is first aid and driver seat is fire ext.

Only one military Jeep had a tailgate, that being the M38. A M38 repro body will have a huge rectangular hole in the middle of the dash board for the instrument cluster.