Search results

Try 7529312 on ebay M939 series 5 tons have the door vent I think you are hunting. Check out Cab Ventillator door, M35A2/A3, M809, M939, 2510-00-546-4759 on eBay...

Typically the units rarely fail. Regulators go bad and are out there. You need to download the alt spec sheet by part number. Sometimes they have the parts breakdown. There are niehoff approved dealers and they would probably be the ones who could order.

Very Cool and Congrads! Where was the show?

They are 400 -500 gallons depending on the tank. Still correct that you need brakes for many reasons!

149's have a cradle type frame to accommodate the tank and lower center of gravity. Older series like the m107 have a straight frame like a m103/105. Infrequently an empty 149 frame will be listed. More frequently will be tanks by themselves. The $ in resale are the bread boxes, valves in the...

empty I think you will squeak under the 3000lb most states use to require brakes. Not sure if tank is fiberglass, steel, or aluminum as all 3 out there, Any amount of water will make you very un safe without brakes.

Welcome to the madness from the big easy. Where are you?

Insanely difficult steering,? Does that mean the wheel is hard to turn? Do you have any hydraulic winches? Hydroboost typically when bad will give you a hard pedal with no assist. Is anything leaking? On a previous thread it was suggested a hose can be the issue. They are all field...

Most stupid design for a water pump in history. As simp stated get the crush copper seal. Do your research as many thoughts/opinions on what does or does not go on it. I recommend picking up the plate gasket for the water pump and change it at the same time. Pain in the butox that job is

I suspect the shaft seal stuck/froze due to sitting up and destroyed itself once it had tension from the belt spinning it. I think you will need a water pump. Typically they are designed to leak from the weep hole.

Typically I have seen most as slantbacks with military police stenciled on sides of slant back. Seen pics of a ibis tek light bar that had blue flashers on one.

My experience with some of those chinacom bbq covers holding up here in the banana republic have been very short & disappointing..... I hope you do better

I might have the cable to the mt2011.

Yes, if you do not use a tilt adapter that antenna since it is so long with 4 sections will get fouled when not in use: https://www.ebay.com/itm/204309006034?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=zFbiGMutQz2&sssrc=4429486&ssuid=XRGgVfBOR1i&var=&widget_ver=artemis&media=COPY The at1011...

That is a 2 piece rubber isolator/protector for the mount that holds an at1011 antenna and the tilt adapter. Some pics here : https://www.hmmwvinscale.com/harrisradiosystems.htm I also have the set up on the side of my right rear fender if you look on my thread Juan's m998

My understanding is that they were only used on armour like apc, tanks etc

I had to change one due to rusted out flanges cracked at the exhaust manifold. My recommendation if the pipe is good otherwise, cut that critter off and be done with it. The job in not crazy stupid but no walk in the park either aligning the exhaust with the muffler and access to the exhaust...

for old guys like me, use oversize washers and a plain thread nut with an impact to seat them. Just like doing an automotive stud on your car/truck.

suction cup will take care of that...... :rolleyes:

I need to verify but believe I have a front fixed leg. Send me a pm