Search results

I am gettting ready to do the front axle wheel bearings and seals, I found bt searching the messages that I can use TIMKEN 392 inner bearing and TIMKEN 3994 outer bearing does anyone know what the seal numbers are? I know its kinda late so I will check back in the morning to see if anyone might...

I have a Question about going down hill on mountains, I have driven 18 wheelers and know how it feels to go over the top and being in a few gears lower while gently pressing the brakes to maintain a slow but steady descend. How does the m35 react going down mountains? does the engine hold her...

I had searched the site before posing this question...... today I started up the deuce and went for a drive I noticed the brake pedal was a little spongey at first then it tightens up good, if it sits for about 4 or 5 min without touching the brakes it feels spongey and goes about half way...

Since Not much going on here I thought I would see what everyone is planning on doing this weekend I myself am going out to WV for the weekend for some quiet time ( I have to leave the m35 home this time to long of a drive for such a short stay) I'm going to leave tommorow after work...

I was changing a steel line on the rear axle for the brakes and I ended up cracking the brass fitting going into the back of the wheel cylinder(the one that the bolt and the copper washer go through). does anyone know where I could locate at least one or more or even a part number. I tried a...

Ok gang here's the question, but first a little story that goes with it I replaced the boots on my m35a2 during the replacement I cleaned up the knuckle area it appeared to be a mix of gear oil and lots of grease(very messy) I used new clamps, when I installed them I put them on tight but not...

My question is about registration and inspection I have successfully registered my m35a2 at 20,000# I read somewhere that I dont need to have inspection (I think it was one of MV Trucker's replys) is this true? I asked the person behind the desk at dmv and the response was not what I wanted to...

Ok first I was a little leary on posting these because it was a fire truck and well it still looks like one I was going to paint her up OD but after some thought I cant. You see going back 3 weeks ago I picked her up in Long Island,NY I drove it home(180 miles +-) durring the drive home I...

I was wondering where hey hide the vin# and if it is located in two spots? Thanks. Jim

Hi Guys, I have a question about the metal brake line comming off the rear of the master cyl it developed a pinhole and I lost brakes. is this any special line or can I make one of these? and does anyone have any secret tips to take one of these lines off without stripping the nut? I tried...

Hello, I was wondering if anyone knew the part numbers for u joints for a m35a2 on the driveshafts mainly the front driveshaft front ujoint. Any crossover stuff would be great. Thanks guys, Jim