Search results

I have been going through a lot of issues with my MEP 004. Replaced all diodes in the exciter unit as well as alternator and starter issues. I now have voltage and most everything seems to work. following sewerzuks video on 3 phase to single, I took the board off, yes all 12 nuts, and noted that...

I was sitting in my hangar yesterday and was visited by someone that I know that was selling a 109A3 to a guy that was on his way to pick it up. As it turns out, this guy bought a M109A3 here on the SS site unseen. He was enroute from Kansas to Tampa on a motorcycle to pay for it, load up his...

After about 1 1/2 hours of searching this vast site I am unable to find the wiring schematic for the M109A3 converter unit and how to wire the rear fuel heater to it. I have a rear heater but don't know where/how to connect it to the converter. This unit has never been installed completely in...

I have been playing around with this STE ICE (junk box) quite a bit lately and decided to use it on a Duce that a friend wanted to buy. I know that many people don't like the Junk Box and think it is not useful. The manual is not the easiest to follow but after you use it a few times it gets...

There is a post on SS about the carrier bearing but no part numbers... Anyone know of a civvy part number/conversion for the carrier bearing? Although the bearing is seized the rubber can be salavged. It took a torch to heat it up enough to get it off the drive shaft. In doing so, the bearing...

Hi guys, I changed the IP and now she runs but with several issues. I don't know how to adjust the Fuel Rate and have no reference to a manual to tell me how to do it. also, I have an occasional pop or rather a hollow sounding miss. I assume it is an injector that might have gotten a piece of...

Just a tidbit of info. I needed a fuel tank sending unit for the Goat as mine was TU. If you take a M151 sending unit and swap out the float it will work. Took about 5 minutes and now I have an operating fuel gauge.

Don't want to sound stupid here but I have two questions.... 1) I have an injector pump labeled LDS 465 1A. The engine is an LDS 465 1D. Will the IP work ( I assume it will) and do I have to do anything different? 2) I can't seem to find the manual or a reference to how to time the IP. I do...

While removing the transmission for a clutch change, I noticed that when the Hi/lo lever that the transfer case input shaft moved in and out. The yolk ( I guess that's what it's called) is loose on the input shaft although it is down tight. The whole shaft moves about 1-2 inches fore and aft...

Howdy all, First time lister here. I've owned a Goat sinse 99 and have quite a few miles on her. Long story longer, I decided to put new brakes on her and got to digging and decided to change the Ball joints too. That led to A frame bushings. Seems I have enough ball joints +2 extra but only 8...