Search results

I have a Davey 7MC2-A compressor that I purchased from GL. I had hoped to use it for sandblasting. I worked on it and got the Hatz 2G30 engine running. The compressor will only produce about 50 PSI. Do any of you know anything about this compressor or where I can get parts. Davey closed...

I have a Davey 7MC2-A compressor that I purchased from GL. I had hoped to use it for sandblasting. I worked on it and got the Hatz 2G30 engine running. The compressor will only produce about 50 PSI. Do any of you know anything about this compressor or where I can get parts. Davey closed...

The TM's call for new locknuts to be used every time the wheel is broken down. I have searched the post and I can't find any one that referred to replacing them. O-rings and grommets are replaced, but not locknuts. What do you say about the need to replace the locknuts? I assume that this...

I have an M35A3 that has numerous John Guest plastic air fittings. I have tried to remove several that were installed into brass fittings and they break off each time. They were apparently installed with pipe dope. The plastic that is left is tougher than I thought and I can't get it out without...

I am making a trip from the Atlanta area to Gulfport, MS for a pickup, a pickup at Eglin AFB and return to Atlanta the week of 6/18/12. I plan to pick up an M35A3C in Gulfport. If I could help pickup or deliver, I'm available. Assistance along the way in case things don't work as planned would...

I have an M35A3 that has not had a problem with the turn signals until just recently. The front signals operate correctly, but the rears seem to be "out of phase" with the lever. When the lever is turned to the right turn position the rear goes into flasher mode. The right, left, and flasher...

I need to get a set of troop seats and sides for an M923 (12' side pieces) from SS member in Bradenton, FL to the Atlanta, GA area. Is anyone headed that way?