Search results

Is the correct fuel pump the AC Delco 43254, and is Permatex an acceptable substitute for the gasket between the block and the mounting plate? If not, do you happen to know the part number for that gasket? Thanks!

When I lift up a plastic flap and install the sockets, the bulbs light up. If I try to install the sockets with the plastic flap between the socket and the housing the lights do not work. Is there an additional thin plastic flap on the outside of the circuit board or is it just one film of...

Just saw the attached picture of the circuit board. Thanks

Any suggestions for getting the final 1/4 turn without breaking it? What does the circuit look like on the back, and could I damage it by cranking too hard to get these sockets all the way turned?

Wow, thanks for the fast reply! Thanks. Just got the pictures uploaded

Hello Everyone, Could someone tell me if the GEN 1 and GEN 2 sockets need an additional counterclockwise quarter turn (see pictures)? It appears that they need to be rotated about 45 degrees counterclockwise to be fully installed. This is as far as I can get them to turn by hand, and I...

M1009 CUCV Wiper motor replacemed, washer and intermittent dont work I replaced the wiper motor with a new unit, and now washer and intermittent don't work. I put a meter on the wire harness and there is no power to both 2 prong harnesses, only the 3 prong one is hot. fuse is good. Any...

Sorry, I did not bump it. I wrote a new comment about hearing the relay clunk. Then I saw that you can just edit the original post, so I cut and pasted it into the original post.

,

Thank you to everyone who posts on this site. I really appreciate it. My '85 M1009 was running pretty well. Hard start sometimes, so I just replaced the very old glow plugs as maintenance. After changing the glow plugs it got cold and won't start. I followed the "Glow Plugs" trouble...

Do you have a part number for the stock GM unit?

Don't know why it is posting the picture upside down. Sorry about that.

The 5 watt 300 ohm resister is mouser.com part number 660-MOS5C301J. It cost about $1, but cost $5 to ship. It it has thick insulation on it.

Voltmeter works great with new resistor. Thanks for all the help.

Warthog, Thank You! Got the bulbs out.

"... disconnected to he to the voltmeter..." Should say "disconnected to GET to the voltmeter". thanks.

The instrument cluster plate is off, and the wire harness to the wait light needs to be disconnected to he to the voltmeter to replace the resistor. The wires aren't long enough for me to get my hands in there, and I can't see what kind of connection it is. Does anyone know if it is an...

Also, the 4wd light has never come on.

Last night I had to drive through the snow. I locked the hubs, and going about 10mph let off accelerator, and pulled shifter straight back to 4hi. Everything seemed fine until I started fish tailing like I only had rear wheel drive. looking down at the shifter, I noticed the white indicator...

To change the resistor on the back of the volt gauge, do you just remove the screws in steps 1 and 3 (pg 4-16) in TM...-20 to pull out the instrument cluster plate and disconnect plugs from the back of the plate to access the resistor? In other words, will I need to do any of the disassembly...