Search results

So I am just in the middle of new transmission and clutch install on my M813 my truck seems to have had a aftermarket pressure plate installed . Ive had the flywheel resurfaced i went to install the new pressure plate and friction disc and there is barely any grip. Using the information in the...

So about to do a rear main seal and speedi sleeve on my 813 who's done one did you find a way with out the install tool?. If you took the rear of the engine off how did you deal with the run out test on the crank after re install . any help would be great cheers. Sent from my LG-H812 using...

This is scary M10 Tank out of control in chilliwack BC. No was killed thank goodness .. View Video, http://s55.photobucket.com/user/northmedic/media/Mobile%20Uploads/ThisOne-1.mp4.html

I did a quick search, didn't find much on the topic. None the less, I picked up some universal test strips and checked my antifreeze and found it to be at a PH of 9, which under10 is when electrolysis can begin. The PH should be 10 or better now you can fix this by doing a Complete coolant...

Hi guys I've tried the search and no luck tried oil change , oil etc etc no find .. What are you guys using for oil I have the Rockwell service manual here and it clearly states to only use GL 1 90 weight oil which is a mineral base and to not use higher gl rated oils as they are not mineral...

So I've read all the tm and not much I can find about this problem under no load front drive shaft spins drives the front wheels .Today I wanted to make sure the front axle was engaging this is what is noted as you load up the drive line the front drive shaft starts to turn moves about a half an...

The family and I found out about a show at 2230 the night before the show. I was working night shift. I raced home after work, a 12,hr night and a one hour drive home, swapped a front tire, did a full pre trip and ran the truck an hour back to the show - lots of great trucks and armoured...

Hi gang Anyone seen this is there a reason or cause there is no damage to the spline on the axle shaft .

Hi Guys I am in Need of Front Harness for a M813 I had a new one that cam with the Truck but it has no alternator Circuit etc I am now thinking it may be for a earlier 5 ton also no cold start circuit . Non the less Hope there is a source for a New drop in harness Cheers

Working on replacing the master cylinder and Air pack and using the TM. I am having some issues with the air fittings that go to the air in specific the one in front of the top bleeder mine seems to have had a check valve in it is this right or like the TM shows only a 90 . Or is that Part...

Help with Cab restoration M813 pics added So now that I am Knee deep Into working on my 813 I have tried many searches for where what goes I looked behind the dash there are Certain key pieces missing I have no connection to the Volt meter Only gauges working are air pressure and Oil as well...

Hi gang the Noob here hope this is the right place to post this So Picked up an M813 Friend and old owner stated that the brakes just failed pedal to the floor .. Working on the truck today I looked at all the lines found no leaks Nothing running from Drums master cylinder is Bone dry ...

Hey gang new to the site and have wanted an m813, for as long as I can remember . And my dream came through .. great site thanks ..