Search results

I struggled with getting my first 531 running until i figured out that the Supertrapp disc/exhaust tuning diffuser was hopelessly plugged with oil and carbon. My experience with Supertrapp exhaust systems was with 4 stroke dirtbikes where you could tune the bike by adding or removing discs from...

I acquired two 55 gal drums that contained the hydraulic fluid for an elevator that was just installed. Other than rinsing it out, is there anything else I should do prior to filling them with diesel for long term back up generator storage?

My tank is leaking real bad around fuel shutoff valve, is that part available anywhere? I found the one for the fuel line feed on ebay, but I cant find the one for the valve. (it looks bigger)

When I received my 531, the air filter was soaked in engine oil and there was oil on the air heaters . After I repaired the fuel lines and got it primed, she started righht up and produced good power but she blew liquid oil, water and smoke out of the exhaust for about an hour, then it cleared...

Here is a photo of my completed BAPU setup. I bought a spun aluminum 5 gallon tank and some fittings, mounted it the the frame (which is aluminum btw) it works quite well. Other rhan the fact that it wake the dead because its so freaking loud). Anyway, now i am waiting for my 24 volt inverter...

I have a new to me 831. 95 hours, runs fine, but has givernor issues. The mainproblem is that the circuit interuptor for the lug terminals trips with almost any load. My skill saw instantly trips it, but the same saw works fine on the convienece outlet. Is the circuit in nteruptor adjustable for...

I have an LTT chassis trailer which due to GL's typical careless, rough, forklift handling has a totaled jack. The teeth on the gears are broken, the latch pin is bent and the threaded shaft is seized. These appear to be made by BullDog, but I'm not sure. I went to a local trailer hitch place...

Bought a magnum mmg25, its on the light tactical trailer chassis, unknown hours but engine bay appears to be new/lightly used. Its 3 phase and 1 phase. gl listing says it doesnt start, i wonder if thats just because they dont have the keys?? Oh boy, what did i get myself into! will magnum sell...

Its a criminal shame that the m998's are being given away to foreigners or scrapped when they would be fabulously popular here. What congressional avenues would be effective in achieving this end? Are the DOT issues the only thing between me and an m998 auction on GL?

Are the floor mounted tie down d rings in the m1101's strong enough for upright motorcycle hauling?

The "serial number" one? or the "registration Number" field?? (m1102)

This may be a dumb question but will it damage the canvas if i travel at 65 mph with the top on my m1102?

I have several extra H2 wheels with BFG 315's on them, will they work on m1101/2 trailers?

The bottom of my 2" receiver is at about 22.5", the M1101 spec is 29.5" to center of lunette when trailer is level right? So, how high do i need to go to get trailer level factoring in tongue weight drop? I see 5" 7" and 12-13" versions, any chance someone with same truck already figured this...