coachgeo
Well-known member
- 5,147
- 3,462
- 113
- Location
- North of Cincy OH
Yup... that tis be what i was thinking off.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Airlift/tie down bar steel grade
- Thread starter BigMontana
- Start date
coachgeo
Well-known member
- 5,147
- 3,462
- 113
- Location
- North of Cincy OH
hmmm... guess one could put a giant rear slide out with something like that.
- 881
- 521
- 93
- Location
- tucson AZ
I have repurposed them by cutting them down so they fit between the frame rails, like crossmembers, the weld mounts to them for other stuff such as an electric crane.
In a prior iteration of LMTV, I used them partially extended as an anchor point for roll over protection.
In a prior iteration of LMTV, I used them partially extended as an anchor point for roll over protection.
Last edited:
Third From Texas
Well-known member
- 2,766
- 6,498
- 113
- Location
- Corpus Christi Texas
BigMontana
Member
- 58
- 50
- 18
- Location
- Polson, MT
See yes, it's stuff like this slide RV build that i'm talking about. why use a custom built rail system so you can keep your giant unaredynamic box...why not just use a big rig tail gate hinge from an end dump truck, and use that to support something that folds out from travel position, instead of slides out.
Cost of custom slide out? $1500?
Cost of Big Rig end dump hinge and a few feet of iron pipe? $150
I think it's funny that they are building thin steel structure above this thick ass i beam just waiting to have something to hold...the design of the truck was to support a load, so let it support a hinge.
Cost of custom slide out? $1500?
Cost of Big Rig end dump hinge and a few feet of iron pipe? $150
I think it's funny that they are building thin steel structure above this thick ass i beam just waiting to have something to hold...the design of the truck was to support a load, so let it support a hinge.
BigMontana
Member
- 58
- 50
- 18
- Location
- Polson, MT
see, yes i love this non-basic thinking...this is why i'm here. people who do something weird are cool.
Last edited:
BigMontana
Member
- 58
- 50
- 18
- Location
- Polson, MT
Think about the hinge idea on the back of the truck, you could have a fold out extended living surface on one side, and a lever to bring a motorcycle (say a Rokon?) up behind the truck tailgate and into stowage/travel position -- build some protection around it and carry it high enough to still use the off road capabilities of the vehicle, and bring a dirt bike. If you work the idea right you could use the same legs you fold down to support the end dump hinged tailgate to make up the exterior of the bike carrier on the front and read of the bike...you just need a bike that's shorter than 7 feet or so...lots of those exist.
-Deke
-Deke
BigMontana
Member
- 58
- 50
- 18
- Location
- Polson, MT
See, EG:
Half-Pivot Greasable Hinge, Dump/Tilt Trailers | Nationwide Trailer Parts (nationwidetrailers.com)
If you already own a winch setup and takedown are effortless
Half-Pivot Greasable Hinge, Dump/Tilt Trailers | Nationwide Trailer Parts (nationwidetrailers.com)
If you already own a winch setup and takedown are effortless