Ours is outfitted for hauling tools and equipment to support the other vehicles as well as around the farm. Nothing special but we enjoy having the truck.
I can't find a picture of the truck completely outfitted, as we always set it up for what its needed before we leave. But it holds most everything. Some of the pics of the truck are before it got its camo job.
The truck hauling the expedition camper before we did a convoy to the latest MV meet.
The MEP903C we installed which replaced the old gas generator/welder combo (which was hacked to death and not working when we got it). Replacing the old generator caused the truck to loose a lot of weight. The new generator is still heavy but I am sure it weighs less than the old one.
The truck is wired that the generator can also power the house or anything else needed.
We have these outlets setup on both sides of the truck as well as in the rear for easy hookup of 120V or 240V
We also installed lights around the truck for use at night with switches on the dash for easy use.
Drivers side of the truck with some gear. The drivers side mainly holds vehicle maintenance equipment.
On the passenger side we decided that a toolbox was in order to properly hold the hand tools and stop them from flying all over the place.
We had to cut out the back of the wall to get it to fit, but we were still happy with the result.
You can also see in the second picture, above, at the top left hand of the tool box you can also see one of the interior lights that we installed to make working in the truck at night easier. The switch for the interior lights is with the generator control panel.
One interior shot. Most of the gear was removed when we took the picture (we had just installed the air reel). But there is usually a welder and portable torch pack in the back.
Like I said before, the outfitting of the truck depends on the situation. Some times it is crammed to the roof with truck parts. Other times it just has the basics as we just need the generator to power something. Last big job we used it for was to build new gates for the property. So it held the welders and other metal working equipment so that we could get the job done.
