• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Blower/heater M1165

K

Karl kostman

Well-known member
Steel Soldiers Supporter
2,308
893
113
Location
Fargo ND
Confirm in your TM that its a ground and you should be able to attach it to anything solid and close to the firewall, just make sure that whatever your attaching to is not rubber mounted.
 
A

Action

Well-known member
3,576
1,557
113
Location
East Tennessee
jim1131 said:
Not getting any heat when I flip the switch to heat. Does this wire have anything to do with it and where does it ground to?
Click to expand...
Look on the other side of the unit for the ground screw.
To get heat, you also need to turn the fan on....and the engine needs to be warm and running.
And if going from a/c to heat or the other way, it takes a minute or so for the water valve to move.
 
Last edited:
  • Like
Reactions: OBX
J

jim1131

Active member
118
35
28
Location
Illinois
Action said:
Look on the other side of the unit for the ground screw.
To get heat, you also need to turn the fan on....and the engine needs to be warm.
And if going from a/c to heat or the other way, it takes a minute or so for the water valve to move.
Click to expand...
On the back side of the unit? Also engine was running, 200 degrees and had it on heat for over 10 minutes. Do you know how to test the valve?
 
Retiredwarhorses

Retiredwarhorses

Well-known member
Steel Soldiers Supporter
4,397
4,181
113
Location
Brentwood, Calif
That is the ground that should terminate on the fan motor, left side, it’s a fine thread 10/32 nut.
The hot water valve fails in an open state, it only closes when AC is selected.
 
You must log in or register to reply here.
110,879members
165,312threads
2,326,207posts
1,985online users
Top