-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Blower/heater M1165
- Thread starter jim1131
- Start date
- 2,308
- 893
- 113
- Location
- Fargo ND
Confirm in your TM that its a ground and you should be able to attach it to anything solid and close to the firewall, just make sure that whatever your attaching to is not rubber mounted.
Action
Well-known member
- 3,576
- 1,557
- 113
- Location
- East Tennessee
Look on the other side of the unit for the ground screw.
To get heat, you also need to turn the fan on....and the engine needs to be warm and running.
And if going from a/c to heat or the other way, it takes a minute or so for the water valve to move.
Last edited:
On the back side of the unit? Also engine was running, 200 degrees and had it on heat for over 10 minutes. Do you know how to test the valve?
Action
Well-known member
- 3,576
- 1,557
- 113
- Location
- East Tennessee
Did the blower fan come on at all?
I think the screw is on the driver side of the unit.
GuntherRommel
Well-known member
- 264
- 525
- 93
- Location
- Bend, Oregon
Maybe the diverter cable came loose, or your diverter valve is plugged. You can service yoursekf
Action
Well-known member
- 3,576
- 1,557
- 113
- Location
- East Tennessee
There is no diverter cable.
GuntherRommel
Well-known member
- 264
- 525
- 93
- Location
- Bend, Oregon
how about the one that hooks to the back of the heater core with one small screw
Action
Well-known member
- 3,576
- 1,557
- 113
- Location
- East Tennessee
There isnt a diverter box to hook a cable to.
If he wants to divert the air, he has to open or close each vent with his fingers.
M1165A1
Well-known member
- 413
- 859
- 93
- Location
- The High Country, CO
If the fan blows but it ain't hot, you might need to replace this solenoid valve:
- 4,397
- 4,181
- 113
- Location
- Brentwood, Calif
That is the ground that should terminate on the fan motor, left side, it’s a fine thread 10/32 nut.
The hot water valve fails in an open state, it only closes when AC is selected.
The hot water valve fails in an open state, it only closes when AC is selected.
Action
Well-known member
- 3,576
- 1,557
- 113
- Location
- East Tennessee
Left side of pic, just below heater core
.
.
.
.