Recent content by hokie8358

The only thing I’ve done differently in the last week. Was install a new dash pad, But I never hit any of the wiring harness or remove the instrument clusters, I did use dialectic grease on the clean terminal ends when reinstalling

This is a damn nightmare lol

I did replace fan with a good one that I also checked before I installed it, also the resistor beside it with one tested and good! crank truck , hit fan switch to medium speed, no fan still and gen light 1 on ! Cut switch off from fan, gen 1 light off! All alternator functioning as they should...

I’ve got same problem and just encountered this issues! What did you find out on your dilemma? Thanks

when I pulled the winch control panel and looked inside. I saw we're they wrote on it new in a sharpie. which, that could've been 2009 for all I know!

10-4! thanks for the quote! truck was overhaules and new tires back in 2011! so I say I need to check everything air leak wise! just shut truck off and heard windshield wiper leaking on pass. side! thanks

just found this question on forum and I was going to post the same questions in regards to CTIS operation on initial startup. my m925a2 has been sitting for about 3 weeks without cranking. I am in the idle of a cab resto. job with upgraded air ride seats and floor rhino liner. when mine is...

I just noticed helo's post on air dryer!!! mine is doing same thing!!! thanks very helpful!! guess its best to replace the whole unit!!

I just noticed on my 93 Harsco m925 cargo truck, that the rear air dryer was making a strange purging sound. after it reached 120 psi, and pop off valve blew down. started making a sound as if it was a compressor running. after that I climbed in cab and had a low air alarm and noticed secondary...

I just was making sure as to not mess up or trash the ctis some how by inadvertently taking it off or capping it off. knew it had to be placed there for a reason!!! lol just was trying to jeep more air psi in that secondary tank! it bleeds off pretty good and with the treaded plastic bottom...

so whats the overall purpose of the collection inline strainer for the ctis? and superman are you referring to unscrewing the bowl and take out the internals? and just to be clear. you are or are not suppose to cap off the bottom? because some people I ve talk to , don't have them on there...

I ve noticed since getting 925a2 in last 5 weeks that there's an inline strainer or moisture collection bowl under dash behind were air line goes in at winch controls. There's a threaded cap to bottom but no cap! This is way I purchased it! I attached a pic to see if anyone else's trucks or...

yes I checked that as well on lower column. looks good as well.

I just got my first 1993 m925a2 truck about 6 weeks ago. Horn worked fine the first couple times i used it. After i got it to the house 275 miles later and it sit for 3-5 days,nothing!! Would not make a peep or nothing after pressing horn button. Heard a couple solutions and tried them. Took...

I have a 86 chevy cucv m1028 and just blew out the tranny. My question is, i purchased a 86 model 454bbc motor with the th400 trans hooked to it. Both had been rebuilt at the same time. I think 2500 miles on the pair. The setup came out of a 86 motorhome 2wd. The tranny still has the trans brake...