Recent content by robesetz

:-)Sorry guys I tried to delete the posting but it wasn't cooperating so I just edited everything out. Anyhow, I've had my M1028 apart for about 4 months waiting for some time to replace the Flywheel. I replaced the flywheel(I know I know, its a flexplate) and it started fine but after about...

You might want to check that spin on filter setup for leaks. Just a thought.

6.2 engine Maybe this will help.

Cucv As stated before you are occasionally going to have issues with these trucks. However, I would recommend going through the -10, -20 and -34 and doing a by the book(s) service. start at the before operator level checks in the -10 and go step by step through to the bi-annnual service. Not...

Maybe this will help?

I would call it a proportioning valve also but the -20 calls it a combination valve. Rumor has it that It does a little more then a run of the mill proportioning valve. Reguardless of what its called I still need one! Thanks.

Thanks, but I have a M1028 which requires a differant valve.

combination valve Southdave, Did you ever find a combination valve? I think I need to replace mine. I had multiple problems with my brakes and lots of leaks so I replaced my hydro boost, Master cylinder, rotors, calipers, pads and rubber lines. Everything bleed well, clean fluid all around...

Confused again! South dave, I though you didn't have to bypass anything if you use AC60G's, Just the blade width was differant? I thought I had this GP thing figured out?!

found the answer. Never mind guys. I found the answer I was looking for. Seems its just best to get the stock system to work properly. Thanks.

24V Glow plugs question. If I have a set of 24V glow plugs for a HMMWV 6.2 can I use them on my CUCV, Just by bypassing the resister and using the round style connectors? Do I have to swap out the GP relay also? Thanks.

I just purchased my M1028 and everything is OEM. All the components tested ok, just need plugs. I remember seeing a post stating the wellman plugs are better for an original setup. Does that still hold true? I just hate to buy something new and then having to modifying it to work. Maybe with a...

AC 60G's So is it ok to file down the blades on these plugs? I bought some AC 60G's today but took them back when I realized the blades where to big. should I try to find some AC 13G's? Does anyone know where to find them? Should I just order the GO70 wellmans from www.indusadist.com ?

a. 1GCHD34J7HF311641 b. NG2SCY c. 2320011275077 d. Bought in Sanford NC, however I was told it was purchased at Gov auction in Atlanta, GA e. Bumper numbers have been painted over with black 1987 M1028, Thank You.