Search results

It sure has.

Merry Christmas and a happy new year. Beautiful truck and dog. Mark

He doesn't drive around with the "guns" mounted . He sets them up for shows and parades. They are replica guns. Mark

We must prepare for all contingencies, Known and unknown.

A buddies truck. Insane. Mark

What does the hart top go for these days?

Welcome to the green metal psychosis. Very nice looking ride. Mark

I actually have all the brackets from a M37 to setup troop seats in my M101A2 I just haven't gotten around to it. Mark

I can see it for parades or running support at a boy scout jamboree or something like that but that's about it. Mark

For LED bulbs and blinker issues they can now be had with a resistor in the bulb base. Much better choice then wiring in resistors (ugly) to give a load to the blinker controller (Anti hyper flash). I used these types of bulbs on my motorcycle for a clean install. You'll pay more but it's a...

The worst one I fount was the drivers rear plug. There's just no room. Mark

I personally think someone is building a fort out of the doors. Nothing else makes sense. Mark

Good deal. Luckily you only had one snap off. Hope you used never seize on the new threads. Mark

Then you don't know what you're talking about. LOL That's a lot of gear to go in the truck. Where are you going to mount it all? I would love to put a AN/GRC-106 setup in mine but I have an old Kenwood 520S that would fit nicely on the radio shelf and it's a good working unit. A Clansman...

I use the wix 51061 for my M998 6.5L. I'm a big fan of Wix and Hasting/Baldwin. Just about everyone here uses Rotella 15/40 T4 (dino) motor oil. Mark

I concur Mark

What bands will you be using and will this setup be used stationary or mobile or both.? Mark

Putting a two foot Cantilevered extension on the bed will cause a number of issues. The center of gravity will move aft which will take weight off the pintle depending on how much weight is in the redesigned bed. It also comes down to the weight of the towing vechicle to deal with the...

I've purchased a number of items from Beltfed and never had any issues and the service is top shelf. I just can't believe how much parts cost has increased in the last few years. Like everything else I guess. Mark

I've started my truck at 10 degrees F and it starts fine. If I would be starting her much lower I would get a block heater. Below are the type of units I would routinely use for cold winters in NH. So easy to install Mark