Search results

I found the timken bearing numbers for the spindle but it shows 3 bearings. I need the inner and outer one. The numbers I g Found are below. Which ones do I need? LM104949. Or 3780. Or 3490. Should I replace the races too? Thx

NM. Found them.

Ken Do you happen to have the correct bearing timken numbers? Also, will they have the races too?

Thanks, I'll check that place out. With all that said, will a new bearing have to be pressed in place?

A few weeks ago I was driving down the road doing approx 45mph when my front rt tire decided to take a detour. From my understanding the locking washer was not installed properly which allowed the bolt to back off therefore letting the wheel to set itself free. I purchased a new spindle as the...

I finally found out what the vibration was on my 998. While going to a meeting yesterday morning the front rt wheel decided to depart from the vehicle. Turns out whoever performed the last maintenance on it did not use the locking tabs on the washers to lock in the nut. The threads are a...

Looks good.

Don't really live in a high crime area however, you never know. I've had tire covers taken, even wheel chocks that I've used for the H.

I know this is a touchy subject but, I don't drive this off road, I maintain about 35 psi in ea tire. Is that too low? Should I bump it to 45psi? Someone told me a while back that if the tire was under inflated that the run flat could not "situate" itself in the tire and cause a bounce...

This may sound like a dumb ? but , with the cost of antenna's these days, how are you securing them to your rigs to prevent them from being stolen? I realize that just removing them solves the problem and I'm OK with that but was wondering if there was another option? Thx

SO, Not to hijack but, how can you tell he doesn't have radial tires? I can't see squat in the pics. Could be my computer but,,,, Wanna make sure I am not running in to the same situation as my rig bounces at about 45 mph also. I checked front end, etc but can't find anything out of whack.

Give me a couple days and I will check what I have. I picked up some new seat frames that came with new 3 pt belts for hmmwv contact me in a couple days to remind me. They are not here at the house.

What camera is that?

Got it!!! Thanks

Off the top of your head, can you tell me what size bolts mount the M707 antenna base to the HMMWV? Looks like 3/8" wanna make sure Thx

the curtain currently is tucked between the seats and the bulkhead but the strap on the bottom of the curtain is a bit too long so the curtain flaps when driving, hitting me in the back of the head. I also get water that runs up from the back side and soaks the seat cushions when it rains. Was...

I see pictures of other 998's with the curtain tucked between the seat and bulk head and others with it outside the bulkhead. Which is correct? Is it a matter of preference?

So, I have all of the hardware for a 4 man setup?

I picked up what I believe are bows and a C pillar for a 4 man top.Can someone verify this? If not, what do these parts go to? Thx

I have a 92 2 man 998 setup. It currently has the wooden troop seats but I have available the aluminum/metal ones. Which would you use and why other than the obvious maintenance issues with wood. Thx