Search results

There's some on the big auction site too @ $13 & change as well👍🏻

Went to Lake Butler today to pick up a 831a generator, I called prior to give them a heads up. When I arrived Eric already had my gen on the forklift ready to load. Very nice guy, guess he was at Albany yard previously. Anyways big shout out to Eric , thank you sir! Peace...

Hey folks, thought I'd do a review of my experience of trying to keep my 831a mobile. When I first acquired it , I put it on a 40"x48" trailer and intended on parking it next to my 803a on the power end of my house. After finding out how fickle these 831s are to moisture, I moved it into...

If you haven't applied any load to the set yet , the percent gauge is not going to move.

Read post #4 of this thread(y)

Hey fellas, Make sure your gens are down wind from your home's. I'm sure all of us no enough to have them far enough away from windows, garage doors ECT. , but Watch out for your neighbors who may not! There's been 8 deaths since Hurricane Laura from carbon monoxide poisoning from...

How did you stretch the input line, it's tight with the OE cube pump. Have any pictures?

The square pump fittings do swap, but the overall length now (90-pump-45) is increased by 1-5/8" , the hard line can connect but now the input line is a tight stretch to reconnect.

The Cube Faccett, reuse the 90 & 45 on E8135. I've done a Cube to E1074 replacement, but not the E8135. Thought someone recently did but can't find the thread.

Has anyone replaced the Faccett primary pump with the E8135 yet? It looks like a very tight stretch to get the inlet hose to reach ?

Do you leave the machine outdoors? I think they are quite susceptible to moisture & humidity. I live in Florida, hot & humid, mine was throwing the overheat fault minutes after starting. I opened up the fault indicator, no visible moisture, but I dried it out awhile with a hair dryer...

I think Guyfang quoted one time " If you don't have Popeye forearms", you can reach in through the fuel filler and reach the float switch to check if it's stuck in the low position.

I've had a Noco 7200 for a year or so now, recovered 3 10year old yellow tops & maintain 22 other various batteries, wish i had 2 of them.

003A's are getting far and very few on the auction sites. 803A's are still available, pretty pricey if they run, + 10% + state & local tax & GPs credit card fee. Then your recovery/shipping fees. I would recommend just looking at the above mentioned fellas offerings. If you can get by with...

Where are you located, I'm in Summerfield Florida. From what I've seen at auction lately, were pretty beat up and high prices and far from southeast. Jimmy has good units at fair prices. Perhaps he would part with one of those 003s that need work. I'd be willing to help you fix it up, I'm...

It is live data and does not alter manual operation at all.👍🏻

Metal oxide varistor #14D151K, eBay vendor Dalbani ,out of Miami. 5 for $7.95 shipped

I used a strap wrench with nylon band, grab as high on filter as possible.

It worked, I sprayed the crap out of the plug & socket, and it's working as it should again !