Search results

Will give it a try thanks

I parked the truck against a tree started to spin the rear wheels back off then started again the drive shaft and left front tire starts to spin but only rotates about an inch then stops even though the rears are still spinning .. oil is new .. you think sprag slipping ?

So I've read all the tm and not much I can find about this problem under no load front drive shaft spins drives the front wheels .Today I wanted to make sure the front axle was engaging this is what is noted as you load up the drive line the front drive shaft starts to turn moves about a half an...

The family and I found out about a show at 2230 the night before the show. I was working night shift. I raced home after work, a 12,hr night and a one hour drive home, swapped a front tire, did a full pre trip and ran the truck an hour back to the show - lots of great trucks and armoured...

I just used Behr ultra pretty happy and paint damage blast some more on that easy takes walking on it with out damage

Found this pic on Google Second pic is of mine I have three stakes to build with box tubing

For my 813 I used double dressed fir used 2x3 ripped to one inch thick uprights are 46"

Replaced all the troop bows with double edged fir super strong and put the canvas on

Maybe not extreme but enough body roll to hit the fender on the foot step and jerry can mount .

Hi Rich I went over to kenworth and brought the old one to match it up you will have to adapt but still works .Any commercial vechical shop should be able to help you out .

Try opening the turn signal switch mine had one of the point contacts stuck together unstuck it cleaned them up with some fine sandpaper worked great after .

Almost finished the paint work

Let me know if the previous post didn't help and I'll confirm on my truck we just put a new harness in.54 should be the jumper if I remember right

A few more pics getting closer

Pm you a link hope that helps on the tubes .

Check out the vendor section or classified adds here , it's where I bought my rims and a few tires from , from the great help I got on steelsoldiers I believe you need Hemtt rims for 1600x20 will give you the proper offset .as for tubes any truck tire shop should be able to get them

More work on the 813. epoxy bed liner sprayed and sand blasting the exterior and starting the paint will be 2,color cdn camouflage .

I gutted the cab and started cleaning the rust and cut the bad rust out grinded the floor after and first coat of por 15 went on with finish with raptor bed liner . Anyone know where that fitting should connect to I may pull the tranny out and check why its jumping out of second gear and no...

Does anyone know where you get power for the Jacobs brake I made the mistake of not looking before I replaced the harness

I want to thank everyone here for helping so far.