Search results

Good day Have a 1991 Humvee 6.2 and I am wondering what these fittings attached to the radiator are for. Thanks Ken

HI The cables are for radios, Ham and AM/FM . I have an antenna on each rear side. I need a grommet with about a 1/2" center hole. I wasn't sure if there was a grommet that the military used. Ken

Hi Has anyone found a source for the rubber grommets that fit into the rear antenna cable holes. there about 1 3/8" in Dia. Thanks Ken

Hi Thanks for the help. Ken

HI I have a 1991 and am looking for new glow plugs. I see on Ebay that the price varies quite a bit. Is there brands that are good and ones to stay away from? Thanks for the help. Ken

Retiredwarhorses OK,Now you have me confused. First are you saying the PCB has nothing to do with the glow plugs? You said the GP controller is on the water crossover. Where is that located? What is the TCU? Sorry for the ingorance. Ken

Hi Here is a picture of what I have which is a PCB as you had mentioned. Ken

Hi When starting her in 50 degree weather she may cycle on and off at idle for 15 minutes before staying off. When it comes to EESS or PCB How can I tell which? Ken

Hi How long should the glow plugs keep cycling when you start the engine? 1991 Humvee. Thanks Ken

Good day Has anyone added or replaced the pop rivets in the rubber seal around their soft doors. In some areas the seal rotates to the outside causing a poor seal. I have tried to drill into the rod to add pop rivets with no luck. It acts like the rod is hardened steel. I also have tried to...

Good day I built an overhead console for my radio and thought I would post some pics. Made of plywood and hardboard with aluminum edges. Ken

Hi Thought I would try to send a picture of how mounted my disconnect switch. As I said this is in the base of the pass. seat.

Mogman Hi Yes , sorry I ment Jegs. The slave switch is located in the front of the passenger seat base. After I removed the slave connector I mounted the disconnect switch in that pocket. I had to make a plate for the switch to mount in. I hope this makes sense. Sorry I don't know how to post...

Hi I would like to do that but I'm not smart enough to know how to post pictures. Ken

Hi This I know is not new but I installed a disconnect switch today in my 1991 Humvee. I removed the slave connector from the passenger seat base along with its cables. Then using the connectors mounting holes made and mounted a plate to cover the hole and then drilled out the center to except...

Hi Thanks for the replays. I guess I should have given more info. I have a 1991 Humvee in the command configuration with a soft top and doors. The current mounts are the style on the rear on each side. The type with two metal loops under the base. I use one for my am/fm radio and the other for...

HI I have my antenna for a 2 meter radio mounted on a military antenna mount on the rear. The SWR is somewhat high and I wonder If It would be better if I mounted it on the side about in the middle. Also is there a special mount that is used in this location? Thanks Ken

DREDnot Thanks for all the info. It sure doesn't make it easy. I guess I'll wait until I can actually check out various cans in my holders. Thanks again Ken

Hi There are a ton of new jerry cans out there, I need to know which ones will fit the standard military holder. I'm afraid to buy a used vintage one off Ebay because of rust . I got one that the only way it would fit was to pound in the bottom corners so it would fit down to the bottom...