Search results

If you have power on both sides of the flasher when it is removed, it is getting backfeed. I have only heard this with one other persons cucv besides mine. If you take apart the inside fuse panel there is a diode/ resistor. That is what fails and back feeds. I cut mine off and has been fine...

To your turn signals work at all? what if you put on the hazzards? At the bottom right there is a flasher in the fuse panel is that where you are getting power on each side?

Carnac Thanks again for selling me your "house" Just wanted to brag a little here on what i got at the show m116A2 canvas NIB groung rods 4 cucv shackles Hmmwv pioneer tool rack with tools And Ammo boxes. What a great show.

I have it mounted on a m116a2

wouldn't a dead cylinder create a lot of smoke unburnt fuel?

where would be the best place to shoot it at?

its hard for me to compare I have not really seen any others run.

All filters and oil were just done, everything looked good. ~700 hours.

Got a mep-002 a while ago and I was wondering if it is normal for the genset to shake. Its bad enough where it is hard to read the gauges up close. All of the isolators look good. I also removed the covers and ran the genset to watch the blower and it looked fine. So how bad does yours shake or...

Wish you wrote this earlier. I was at the show today and will be in boston next week. BTW, Great show today and I got so much cool stuff.

Love this build. I always wanted a lifted m1031. Thats gonna be the next one i get.

Re-read post 21.

I"m sorry I miss read that.

Same as 12v. Hook the power up to the buss bar with fuse, toggle and ground.

What else could keep the starter from spinning up? Remember, it is known good. the 10 volts at the starter solenoid. I had the same problem.

Are you 100% sure your starter works? and Batteries are load tested?

Anyone have a Oil pressure Gauge for a mep002a?

Jump the starter to see if it even works. Then go from there. What year is your truck?

M116a2 canvas, h1 rims

Did you install the extra ford relay you were going to do? When I got my hacked up M1008 it was so bad I had to make my own jumpers to get everything to work. May not be a bad Idea to rule stuff out. Really need to get the multi meter out and see whats going on.