Search results

I'd also like to find a PRC 138, as I have about everything less radio.

These look like its the same turret as a Hmmwv would have on a hardtop except the coupla / shield There are 900 series 5 tons that use a flat turret plate which accepts Hmmwv turret top parts. There's also a ring adapter for an M1151 that can be used......but hard to find as is with all the...

There all in tm9-2320-387-24p C05 Fig 196G 197A 198 200B

Close to Palmdale

Got some in desert area north of L.A.

There is none that mount to door hinge on a Hmmwv. Windshield frame were they mouint. Some later W/S frames had 3 rivnuts on left side for choice of location.

I took apart a few relay boxes off of early Hmmwv winches, and the solenoids were all 12 vdc....motor was 24 vdc.

Get the 2 pc. cover when you re-install.

The original is dual purpose.....oil cooling connects on left, and trans cooling on right. I don't think there's an aftermarket one out there. There's a new one listed on fleebay for $ 395, but its not for a hmmwv, or H1.

Hummerpartsguy Kascar Macmotors

deleted

1998 would have a different park brake handle [ with a button ], and steering wheel would be the thicker black one. And if a real 1998, it would be a 4L80E truck, not a 3L80 truck. Some Reset places put date reset instead of original date. A good reset facility puts A new data plate, with...

Got no more NOS ones anymore.

Hoses are the same on early H1's But cheap on fleebay

low, or bad batteries and also a Gen. that puts out to much voltage can cause issues also to your S3 box, or any other EESS box.

You probably need another dual switch. The brake switch in that dual assembly do go bad.....had many. If you have to adjust it past the factory settings...its probably bad. Take switch off....remove the screw and spacer to the two levers, and check brake switch.....S/B spring loaded and travel...

The 3L80 shifter....neutral switch hole needs no bushing.....the reverse switch does. If you use a neutral switch as a reverse switch....still needs a bushing. The 4L80e shifter uses an aluminum block to hold both switches.

Here's some different types.

Thats AM general and it fits a bumper that is pre-drilled for it. Like this one I have.

Temp sensors........