Search results

thanks bud

no open. You sure I am supposed to move the shaft 1 1/4 side to side. it seems fine driving it down the road no noises or anything. Its late now but tomorrow ill take it off and see whats going on in there.

I put both trucks on the ground both in park but transfer case in nuetral My k30 had about 1/4 inch of play and seemed normal. the D30 moves about 1 1/4 inches. guess I'm pulling it tomorrow.

or you can have them all pop tested and see if they are any good.

thanks guys I have 2 other 14 bolts so I'll check them and then take off the cover. It just seems there is just to much play.

on my 14 bolt when I put it in to reverse or forward I hear a clunk. The pinion moves 1 inch before it catches I guess the next tooth. I know its not a mount making the noise its the pinion yoke. I had the driveshaft off and with both wheels on the ground when I checked. Any got any answer...

no they are different. you will be waisting your time.

here you go but only do it for 5 sec.

Its supposed to be both. If I was working on the truck this is what I would do. Pull all of the glow plugs and get some jumper cables and a battery and test the glow plugs. If you do not know how to do this go to youtube and look over there. once you verified all of them work put them in and get...

I hope your putting the special acid to kill the rust otherwise it will come right through the bondo

would a 12v starter gear reduction help you out?

replace both torque converter and flex plate and be done with it.

if you have extra cash have them both rebuilt and fix as needed

To give it some power to light up some check engine lights. You need to rebuild passangers side alt. And recharge batteries and then check for 14v at each battery with truck running

Replace bulb or clean contacts on gen light

disconnect both batteries and charge them up. Then reinstall. Turn the key to run both Gen 1 and gem2 should light up. Do that and report back.

Any of the Gen lights on?

someone removed his resistor and hooked it up to a 24v terminal. Thats why he burnt his glows and card. hence new push button and glows.

that sucks you had to buy new glow plugs. were the old ones fried?

I got mine shipped 2100 to ct. Call them back tell them to do the same. Just remember If you don't buy it from banks and you have a problem they dont want to know nothing. I had problems with my kit and I called them up and they fixed everything for me free of charge