Search results

The nozzle can be taken apart , cleaned and re-assembled. The pressure in the feed line (the skinny line) is boosted to about 90 psi by the "flame heater pump" when turned on, otherwise the pressure is about 1/2 that, coming from the injector pump. The return line pressure is much less. It...

Sent you a PM....

Re: RE: Re: Batteries I wouldn't be terribly concerned about the cranking amps, the starter motor in the deuce typically only draw 100 to 200 amps unless there are some seriously cold ambients without heating the engine ahead of time. I would be more interested in reserve capacity and that's...

Re: 24V battery maintenance charger Chargetek 500 is what you need, it addresses each battery individually and keeps both within millivolts of each other, which is what's required when batteries are operated in series. I had one installed for years in the deuce until a lightning strike took it...

RE: Re: RE: changing water hose on deuce I would suggest that you use a tap to clean the threads (3/8-16) and the gaskets are easy to cut from gasket material....an exacto knife works great and a punch for the bolt holes.

Gary, I don't think it matters that much, based on the popularity of this thread, the quantity would be minimal...

Re: RE: changing water hose on deuce Yes, the key is to be able to slide the hose as needed and nothing has to come off. The originals may have to be cut to be removed, though.

Here is the difference, both without the safety upgrade.

Yeah, I have changed all those at one time or another. For the hoses, cut to same length as originals and lubricate slightly so that they can slide back and forth as you install them. I cut my own gaskets when needed and use a gasket sealer (T-stat housing).

It's more of a metallic gray.

Gary, let me know if this is good enough for you to work with. Thanks

RE: Re: RE: Abnormal 3-lever light switch Received two switches from Austin Weber (beltfed34) today and they are both bad.... His descriptin is usually not very complete, so I know I take a chance, but one was crunched from behind with the connector at an angle, the other had a free spinning...

RE: Long Boom Jacks I would be interested in the 5-ton winch snatch block, if original equipment.

My USMC deuce apparently had part of the deep water fording kit factory installed....

Images from the driver's seat.

Do you have a link Mark? Thanks,

Hmmm..... looked here before posting this request: http://www.wacbgmvt.org/ecr/vendor_info.html but didn't find a listing with contact info.....

Is there a listing of the vendors, who were signed up for last year's Aberdeen, I have some second hand information that a vendor from PA may have Ford 8x8 parts and figured I could just call them one by one and ask..... Thanks,

Received the decal from Fred today, much appreciated! Here it is and it's 1.5 x 3.0 inches in size. Marking below frame reads: DA LABEL 132, 1 JAN 80 PREV. ED. WILL BE USED

That's what you get for messing with the "new" stuff. :-)