Search results

Thank you very much I will try the test tomorrow.

I installed the new VR but it doesn't work either. Maybe is something else.

I did the test specified on the TM on H instead of 8 VDC I got 10-11 VDC on J instead of 67.5 to 90 VAC I got 1.5 VAC on L instead of 108 to 132 VAc I got 11 to 12 VAC

Both the light and very low voltage

You are right it's a MEP-806A

I installed the new pump, it starts perfect. Now I have a new problem, under voltage. I replaced the fuse next to the voltage regulator just in case but it didn't solve the problem. Any Ideas

I finally was abled to pull it out.

Thank you, I'm going to work on it, I just received a new voltage regulator

I heated it up till it was red hot, applied the air hammer and it came off. Thank you very much for the help

Hello, I have a 1995 MEP006A with a John Deere engine. I need to rebuild the fuel injection pump. I have try everything I can think off to remove that pump, I even built a tool with a 2 ton hydraulic bottle jack, and applied at least two tons of pressure on it, and it doesn't move. Any ideas??

I ordered a new voltage regulator and still have the same problem. Any other suggestions?

Any idea how to repair or replace the voltage regulator on this unit.?

Hi, I have a 35KW GET with a John Deere engine and a marathon generator. The pump was shut, I rebuilt it and work fine now, but it's only putting 50 to 55 volts.

the problem is the starter solenoid, it was very corroded inside. the cooper filament was covered with a layer of old grease, prevent it from making contact. Hopefully it will start tomorrow when I put it back together. These units seat unused for a long time exposed to the elements I guess.

Hello I purchased two 1995 MEP 806A with under 4 hours. One had an issued with a fuse and it was resolved pretty fast thanks to the knowledgeable people on this forum. Now, the other one won't crank, it makes a one time clapping noise on the starter when press to run. I put new batteries on it...

the fuse was bad and I replaced it. Now its working perfect. Thank you

Hello, I recently purchased a 1995 MEP806A with three hours. The unit starts and runs fine, but the low voltage light is on and it wouldn't let me close the power switch. Any ideas of where should I start looking.

I did get the manual. thank you

You have been very helpful. Here's my email sfus2645@gmail.com

I don't have a manual, I had to reverse engineer the electrical plan.