Search results

I don’t know where you live but here in Florida mud daubers decided to build their mud nest inside the horns and ruined them. When I replaced the horns I put fiberglass screen on them. Just went big with the screen and used a zip tie to hold the screen on.

I did that on my thread Keith’s M1078A1 overland project on this site, page 6 and beyond. Now that I’m full time in it…it’s a must do thing. With our soft suspension it really helps on body roll.

You guys were spot on! They do work as parking lights not running lights. Thank you!

2003 m1078a1, I noticed today that my front running/ parking lights down in the bumper are not working. Rear running lights work and all the cab marker lights work, headlights work. The bulbs are good. The relay is coming on. I may have the interactive electronic technical manual on an old...

After a couple weeks it did it again…..pulled the fuse panel cover off and sure enough the BO relay was on and only the stop light LED was illuminated. I pulled CB66 fuse and the relay turned off and everything was back to normal. I’ll be driving by Superman’s place and pick up an old style...

The original fuel tank is aluminum and was built very well. I would personally mount it the same way they did.

My smaller gasoline tank you’re referring to is not as deep or in other words it’s about 9” away from the frame, because of the spring hanger and other things. Also the short distance between the two L brackets that are attached to the frame are relatively close to each other which meant that I...

I just did it and used the same method as General. Didn’t spill a drop.

Hope this thread helps everyone as well in the future.

Thanks Ron, greatly appreciate all you do.

General you were spot on thanks for your help it only took about 15 minutes and now they are parking at the end of the stroke in the horizontal position. Thank you for your help.

Finally had time and opened the fuse panel and dash panel. The push button light switch does have a separate ground on it. When I turned the two different BO options on the only thing I could see occurring is the hazard relay LED turned off. None of the BO relays LED’s came on nor did I hear...

I was referring to a persons night vision not night vision goggles. Where would the ground wire be in the wire loom or a separate ground wire to the switch chassis? Thanks Ron I’ll get in there and check those things out. When all this rain passes. But you’re confident that those are supposed...

So I just tested that theory and selecting each different Black out option nothing turned the shift indicator/display off. Which that’s why it’s Red so it doesn’t bother night vision.

I’ll check that and I’ll also turn black out on. But in black out mode shouldn’t things illuminated in RED stay on?

Nope, I have the newer style that has the push buttons. Extremely difficult to just turn the stop lights on or service lights. And it just fixed itself while I was out checking tire pressure.

Here’s the scenario, 2003 M1078A1 I’m driving down the beach at the north end of the outer banks NC where they have wild horses roaming around. I turned the CTIS on it come on normal, select XC it aired down as expected. About 1 mile into it I decided to air down to the sand settling again it...

Basically the front hubs need to be filled a little below center of the axle.

I actually built an electric deployable version first that would work when the door was opened. But I felt it had too many parts and hung down more than I wanted it to. So I went with a simpler design that will never fail.

I promise it’s in the mail…..dang USPS! Why are we still funding them. 🤣