Search results

Last I checked, the underneath of the floorboard is what both pedal arms slam up against, so not sure it’s possible to shim either pedal further down.

915A1s went through numerous RESETs, IRONs, etc over their long career. It is my belief that the 400s were evaluated individually and either “painted black” or sent to Cummins for overhaul as determined necessary by the depot.

For reasons I will never understand, 280s never bring under $1000 at Govt auction. Not like dirty aluminum is worth that.

Yeah Case has left me high and dry on machines as well. Is this board mil specific? If not, do any machine dismantlers show to have it? Are there any 3rd party repair facilities available for this? There is a shop that fixes Allison boards. Did you try any tricks to fix your board, like...

Welcome. Read more here: M1165A1W/B3 GMV Thread | SteelSoldiers

Did you order Eastern Surplus part number SP-2839 for 6.2 engine? If you did and they sent you the wrong part they need to make it right. If you ordered the wrong part, like HM182, it's on you.

Yuck rode hard put up wet and too far away. 1968 dated.

The quotes for installed lift gates years ago were 5 digits, more than the city could go for. Hate to think what they would be now with the huge steel tariff increases we are seeing in manufacturing.

These show up on GP Lytle TX from time to time if you can wait

Based on the extreme difficulties we had getting senior citizens and dogs up and down ladders etc, I came up with this folding stair attachment. So far nobody has smashed it, which is this design’s achilles heel.

Recall what all the brake proportioning valve does. If the front or rear brake circuits become unbalanced, a piston moves which activates a switch (pictured) that causes the “brake” warning light to illuminate.

A used oem shock should still be ok. Suggest a wtb ad here for someone parting a truck out.

Agree. Back to brainstorming. Usually with well worn Jeep engines, the pressure can drop to zero when the oil is hot. Not right after starting.

I thought your front driveshaft was bent as well? I would highly suggest you look into the u-joint puller tool, these caps can be stupid stuck in the yokes. Wasting hours pounding and cussing is not good use of your time out there.

Are you experiencing the no oil pressure issue while cranking or while briefly running? If only cranking, maybe that is not enough speed to build up sufficient pressure. I would check mine but it's down at the moment. Maybe the oil filter is not filled yet? The pump does not look horrible.

I can’t remember, is there a oil pisser on the chain drive somewhere that you might have forgotten to put back?

The box will have a conduit attached that will feed into a grommet hole in the cab floor. Positive cable goes from battery to starter, negative goes from battery to frame rail underneath cab.

Hose should not be blocked with anything.

Available repro. Pricy tho

Welcome, yes this forum needs all the knowledge it can get, as every imaginable problem shows up here and some that nobody has imagined. Thanks for chipping in. My father is from nearby Schwandorf, have visited a few times, beautiful part of Germany.