Search results

Howdy. In my 1078a1 I have one chamber that lost the bolt that unlocks it in case you need it towed. Where can i find one?

Im game!

"knowledge is power". Thanks alot Cucvrus.

I once saw a half a backplane on auction on gov planet. It was literally half a board. 😂

Three options available. What would you consider to be zee best? https://www.summitracing.com/search/part-type/flexplates/make/chevrolet/engine-size/6-2l-379/ring-gear-tooth-quantity/139-tooth

No, i did not know they were one and the same. I also did not know that i could replace it without dropping the tranny. Looks like ive got some reading and ordering to do. Thanks alot guys.

So im probably gonna get a new flywheel and flexplate and save them for the day it all craps out. Then just get the starter rebuilt and do all at the same time.

Howdy folks. My starter sometimes cranks but the engine does not turn over. I took off the clutch cover and found that in some parts of the flywheel there were areas shaved off by the starter not engaging fully. Since I bought it, the m1008 ocasionally does it but otherwise it starts right up...

Someones gonna buy a bad backplane soon. 😬

240/416 setup is being reigistered by the CIM. Check the connection board as you might just need to switch it back to 120/208v.

By looking at your pic, it seems you have an 816b not a 806b since it says 400hz, but you have an avr 100 module that is used on a 806b. Send a pic of the manufacturers plate for reference. Also, check the voltage selection toggle swith and make sure its at 60hz. Only move it when the unit is...

In a side note, what is this cable for?

Howdy folks. Happy 4th of July to all. Im having issues with my glow plug system. The controller has the leds staying on after ignition is off with keys out. This drains my battery. Also, when i connect the positive pole it immediately arcs and starts cycling the glow plug relay unit ot warms...

Howdy folks. Im thinking of towing a few hmmwv with an m1078a1 and tow bar. The manual says the pintle can handle 12k lbs and the humvee is under 6500 lbs. Is the tow bar all thats needed? Im really a newbie when it comes to towing so any suggestions help. Just to clarify, this is just an...

If you can, scan the wiring diagram and post it. Back in the day, there used to be cd scratch repair kits. 😅

Looks like the usual bad avr problem to me. I had one that did the exact same voltage fluctuations under load a few weeks back till the avr died. Swapped and fixed it. If no stock avr is available, you can use an aftermarket avr and it will work.

My 2 cents from recent experience. Many of the 802/3 that I have been receiving from auctions have a jerry rigged disconnect cable running from one of the emergency stop terminals through a hole on the bottom of the control cube to the cable lugz (where there is a male and female spade...

First, download the manual and have it handy. Familiarize yourself with the unit. Id change all fluid and filters just to reset the clock and have peace of mind. Excersize all switches with the unit off. Like farming said, those batteries are probably bad. Look up the procedure to trick these...

The issue is that the muffler has an area that is flex piping. When that gasket goes, the flex pipe start rubbing against the genset chassis till it breaks. I have 3 of these units with the exact same problem.

Im even thinking of centering it and just weld it in place. Fuggetaboutit.