Search results

This is a bump to remind anyone interested that the big day is tomorrow. We begin gathering at 6:30 am at the Entry Door on University. Snacks will be about for those wanting a bite before we depart. If you have been thinking about it, quit thinking and do it.

Subject: Medal of Honor Parade Final Update This is being sent to those having an interest in the Medal of Honor Parade, Gainesville , TX . There are changes to the document below from the last one that I sent out. Information; MOH Parade will be in Gainesville , TX...

I am going to have to whip you sonny!

The bolts have not stretched and the thread is sufficient to hold the head in place.

I had not seen that, but I probably will build a sealing plate later just to loan out.

Changed out last Summer.

A couple of hours. Maybe drove it 30 miles.

They are all new and were tightly installed during the reassembly both times.

Get some bio killer from O'Reilly or Autozone.

I have been posting on my problems for the past few weeks. To recap: I had AF in the oil. We pulled the heads and found the number five cylinder had the gasket blown INTO the cylinder area. We pulled the head, decked them looked for cracks, found none and put new head gaskets on. After a...

No question about it. Others may be hard to access but this one requires lifting the front of the motor about an inch or so just to make the last couple of turns. You go crazy for hours, look at the TM's and read NickD's article in the MV mag trying to figure it out. The TM wants the motor...

Thanks. I have added that to the TM's section on documents. We need that made into a sticky here.

Thanks. I just used the term 'thermostat NAPA' and it came up with nothing.

I cannot find the interchange number for the NAPA thermostat. I have done the search but I am not coming up with the list. I saw it posted recently, but I cannot find it. What is the thermostat number for NAPA?

Recently, within the past three years, an acquaintance bought at auction a M113. He was able to keep it as it was abandoned by a foreign government here and did not belong to the US Government. He assured Uncle that the vehicle would not be sold to another without notifying the government...

You are correct. But, I had not seen it or the TM page. Glad JT put it up for copying.

Time is getting close. If you want to join in the convoy, contact Boots at the address above and let us know you are coming and for directions.

I got new head gaskets for the deuce this week. Included was a torque instruction sheet that I had not seen before. I have included a copy of it with this post for anyone who may care about this issue in the future.

The flasher will not effect the brake lights. You might want to contact cranetruck about wiring in some surge protection for the flasher, however.

Each brake light and signal light is grounded at the base of the light fixture, whether on the fender or at the rear, by the mounting bolts. They rust. The inside/outside star washers rust. Get new mounting bolts, clean the bolt sockets also, and new inside/outside star washers to install...