Search results

My power steering started whining last time I drove the vehicle. Today I went out and checked the level while cold, it was right at the perfect mark. I realize it's supposed to be checked while hot in idle, So I took it for a spin, once it got good and hot, checked it again. Was bone dry which...

https://www.youtube.com/watch?v=qZDCBVy22W8

Got a gunners platform, not sure exactly where it gets positioned for drilling holes in the floor?

Got it at Erik's a little cheaper than Kascar, un did the negative ground on the batteries, checked all glow plugs, all were 3.2-3.3 ohms. disconnected canon plugs unbolted 4 bolts and removed box. Cleaned all the areas where the bolts attach to the box, put new start washers and a couple bolts...

I have the original bumper on my M1038, I have the reinforced bumper kit I haven't put on yet to pull bigger trailers, don't have the airlift bumper. My question is, I know the pioneer tool rack will work with the original bumper, will it work with the reinforced bumper? How would it work...

I'm getting ready to install a vic one system AM1780 and 4 Com boxes. I'm thinking, I'm going to drill holes for the boxes in the B pillar for the driver and passenger and use nutzerts and bolts; the C pillar isn't as big so should I use or make some type of bracket or are there special brackets...

What's involved with fixing a broken off pin on cables like these? No wonder it wasn't working right, pin was bent down, when I tried to bend it back it broke off.

Instead of having to get down near a hot engine and screw around with a bolt, Get yourself either a 1/4 inch T with flare ends and a cap, or elbow with two flares. It turns out my shutterstat problem isn't the shutter stat on my M923A2, it was one of the elbows, it has a tiny screen inside that...

Those of you who are waiting on a vehicle from there, might want to check with Jwade to see if any of your humvees got damaged. http://www.kare11.com/weather/storms-blast-mn-guards-camp-ripley/315639739

My glow plug system isn't working right. It flashes once after turning switch to run, then about 3-4 seconds later flashes again, then 3-4 seconds later flashes again...... Does that 4 times I think. Does my TSU need replacement? I put in the ground wire from the block to the box thinking that...

I did a search and came up with group 24 and group 31. I don't think they were in an A3 tray though! The A3 tray looks like it has moldings at the bottom so a 6TL won't move around side to side. So specifically, who has replaced their 6TL's in an A3 and with what? Do the A2 trays have the same...

https://www.youtube.com/watch?v=qMNLtSSjOXY

https://www.youtube.com/watch?v=Ayoczf_Z-6Y

I noticed on all the function checks of HMMWV's the engine is already at operating temp yet they are waiting about 7 seconds before starting the vehicle like they are observing the wait light, which wouldn't come on with the engine at operating temp. Any explanation for this?

For the life of me I cannot find anywhere in any of the tm's diagnosing the wiper motor, which pins should have power. The sprayer works but wipers don't. If the sprayer has power shouldn't the wiper motor too? I have two pins going into the bottom of the wiper switch, I have four pins at the...

Can't tell in the LMC diagram whether the handle comes with the swingout part the key set goes in. The part the keyset goes in is all messed up on mine, I don't see it sold separately anywhere.

I can't find a breakdown of the injector pump in the TM's. I have a leak at the throttle shaft on my injector pump when it's cold but then it stops leaking when it's warmer out, say about 60-70 degrees. Is there an oring that can be replaced with the pump in the HMMWV. The leak is at the...

I always think a 30 minute job is going to take 30 minutes....You'd think I would know by now. I pictured in my head I was going to run my wife's F150 supercrew up to temp to change her oil and filter, while I checked and filled the transfer case since I pulled it into the garage this weekend...

What is comparable generic oil for the 6.2? Does the 10 mean 10w30 or similiar? What does 30 mean? I've never heard of 30w anything????? I want to be sure I have the right oil as the AM General troubleshooting guide indicates if you don't have the right oil, the engine might not spin fast...

I seen to recall someone posting a pic and saying the pillars and bows are different and the top doesn't fit right. I would like to put it on, but if it doesn't fit no sense in trying without the proper pillars and bows. I can't seem to find anything about the top/pillars and bows in the TM's.