Search results

Looks like the fuel supply line that would connect to the metal line running, or would normally run, to the fuel pump. Looks like from the picture there is an spin on filter and other lines running to it.

90 minutes.. I pm'd you my phone number.

I am about a hour and a half south and have plenty of storage space

Oh and unless John and Stan are in a really, really good mood, you will have to take everything in the truck. I would do as Recovery4x4 stated though, move the extras to your truck.

I did go look at it. THe interior is decent. Under the hood looked clean. I didn't look too close at the wiring to see if they hacked it at all though. There was some rust in the cab corners. I dont remember much else to be honest. THe rust did it for me. Thats how the other white one and...

That M1010 has rotted tires on it. It also has 4 tires, 3 with wheels, in the back. 2 are deuce wheels, 1 is for a 5 ton. THe other tire, not sure, but all together thats extra weight as well. 5 lug axles could be 3500 or 5000 lb axles. 6 lug could be 5000 or 5200. Brake drum diameter...

THe pieces are pipe threaded. They taper in towards the bottom. This helps seal things, though you should use some sort of teflon sealant. So, no the adapter should not go clean through.

Im sure there is, They call it a flywheel in the TM. Just have to remove the cover held in place with 6 15mm headed bolts, and the 5/8 headed bolt that is used to secure the clamp on the transmission lines. Look for cracks where it bolts to or around the crankshaft. Also, grab a hold of it...

Have you checked your flexplate for cracks yet?

The Monroe one works pretty good. Easy install. I use them if I replace the damper They are 21.79 plus shipping from rockatuo and if you have the promo code you get 5% off. They also carry the ac delco for around 24

Theres no list, but most list in the description if you can't drive it off the lot anymore. At Jefferson City, You can drive off the lot, they will even help start if it doesn't have good batteries. The number to call to view/set up a pick up time is on your invoice. It will go right to mikes...

3/8 course thread, think 1.25 or 1.5 long. Dont think theres enough firewall to bellhousing room to do that but I may be wrong.

www.classicparts.com 39-045 lmc's doesnt fit too bad. i haven't used classic parts' yet, but may on my next truck just to see.

Are all the wires good going from the black junction block to the inside of the cab?

Nope. Are you gettting power everywhere else needed? make sure the blackout light switch is up. if not you will not have service lights. Make sure the under dash starter relay is there and functioning or you will not be able to crank the engine over by the key. Make sure none of the fusible...

How old are the batteries? What brand as well? CCA doesnt mean much when the batteries are old or have had a hard life. However, I put group 31 batteries with a 960 CCA rating in all the trucks I sell.

rapid flashing other than what has been stated could be the incorrect flasher.

86 09's have a different front seat mount...much cleaner looking. 85 up trucks had frame supports added on each side about where the firewall is

I have seen some NOS on ebay every now and then. Unless theres an alternate part number Im unaware of, GM goesnt sell them anymore.

I would take it back and have them retest it if theres any warranty