Search results

I'm in. Thanks for the follow-up message, Aaron. ~ Thad

Following. I recently bought an MEP-004A that has the same symptoms. I spent a couple hours reading the TMs today, and it looks like I need to replace a few relays.

That's a nice truck, but it's not a drop-side (the "C" in M35A2C).

I'd like three.

Sometimes the SS search doesn't do as well as Google. I did a Google search of SS and found a couple other threads. Bjorn from Crane Truck had success with a similar system, but he treated the filter as a bypass instead of running it inline with the heater. Here are a couple of the photos he...

PS #461 Coolant Heater Instructions Thanks for your quick response. Attached is the photo I found here on SS for the PS article that talked about this. It looks like I got the correct port, but I'm not sure ...

In the summer of 2014, I relocated my coolant cab heater into the cab under the map compartment in my A2 like they have them in the A3 trucks. Here are a couple of pictures of what that looks like: Picture #2 is where the lines come into the cab, from inside the cab. Picture #2 is where the...

I put mine in the rear frost lug hole (closest to the firewall) on the passenger side of the engine.

No mounting clips, no mounting board. Just screw it to a convenient place on the firewall close to the switch.

Hello, I am not a mechanic, so I hope you can give me some guidance. I read through the TM, and I found some pictures of where I have fuel leaking in my MEP-802A. I just replaced the liquid level sensor today, and as luck would have it, now I have a fuel leak. It's leaking at both injector...

I don't have an 1102, but the TM makes it look like the lunette ring is about 24" off the ground. Good luck. http://www.steelsoldiers.com/upload/trailer/TM9-2330-392-14P.pdf

Great thread. This is on my project list. Subscribed.

I used a rivet gun to install two additional tie-down hooks in the back.

I liked the prices on GL better, but then GL screwed me. I like the bidding system better on GP.

I called the Legion at (763) 753-4234 and asked for Laura. Laura is no longer there, but Jen is now doing the reservations for the show on the 19th. Jen works at 5:30 p.m. on Wednesday the 26th, and she is in again on the morning of Thursday the 27th. I'll bring my M35 and M105 down from St...

Subscribed.

I agree 100% with what VPed said. I also had 395/85R20 XML on factory deuce rims when I got my truck, and I had the rubbing issue on a full right turn. I got a set of HEMTT wheels and had them recentered by Stazworks in Wisconsin. Then I put 395/85R20 XZLs on those new wheels and no more...

I took a 2nd look at your photos, and it does look like the bracket is bent a bit. That's a thick bracket, from what I remember. I think if you can bend it back a bit, your problem is solved. The reason I originally suggested to loosen the bolts holding that bracket was that on my system, I...

Correct plug size to replace MFH fuel nozzle Ok, I just heard back from my local machine shop on this plug (Ickler in St. Cloud, MN). I dropped off the actual fuel nozzle/fluid restrictor (Item #25 in Fig. #27 "Flame Heater and Related Parts" from TM 9-2320-361-24P) and they measured it up...