Search results

PB blaster or any other penetrant fluid for a couple of days, then hit it once hard and try to unscrew. Is the 1st thing i would do.

Definitely the rim is bent/twisted. I mounted the wheel on the trailer axle and free spin it to a bad rim. Tire seems to be flat as per my test.

Or probably it got losen while rolling? I can guarantee you that it was correctly tightened to the hub/spindle while in the fron and back. The grease started leaking while on the back and the screeching was not happening and started about 2-3 miles after running. Why, i don't know. Probably the...

No, not me. My truck had 2 imaculate tires in the back, one flat in the front and another blown in the front. Had 2 more on a trailer and i obtained 2 more from a friend. Not sure if this one was on the trailer (i doubt it) i believe this one came from a friend on a donor he bought. I am...

Not sure why so different. It could be that it deformed more while i used it? It did not rub in the back for a couple of days but it gow worse. I did notice also that the grease or whatever they use to slide the run flat inside was dripping through the cebter of the rim and the alignment hole...

Just in time

Ok, i regards to one tire that was wiggling, i placed on the back for a more bearable ride until i buy the new tires. Went a couple of miles around and heard a screeching. Turned out the rim is weirdly bent or not seated correctly. Some pictures of what happened, rim is already out of the truck...

Same i thought, diesel engines (most of them) by nature are low RPM.

Great info. Just ordered the parts and will be repairing. Let's see how it goes

Thanks

Any recomendation of a good seller/part? There are tons of options ranging from very cheap to expensive. I wouldn't like to buy a part that is going to leave me stranded.

Yeah, meant sooner than later.

One thing i noticed though, my left upper rubber boot for the half shaft is cracked. I guess i have to replace sooner than later. I have read on this forum that the way to go is replacing the whole assembly in lieu of replacing just the boot. Also, if i were to replace the half shaft how do i...

Well guys i am happy to report that no parts are damaged. Out of 8 tires i have only 2 are new and the other 2 are decent (not perfect). 1 blown and 3 with flat spots. So i am in the market for new tires, if anyone can point me in the right direction of a not so pricy supplier.. I have been...

I will try a couple of other tires I have on the trailer. Will try to figure out the issue and report back.

I am running Radials.

Yes, the TC is in H. The wiggle is coming from the front left tire. Starts jumping at about 25-30 mph and wiggling after that.

Something that got my attention also is that the gauge does not have red or warning zone , so I figured the temp was about normal however not 100% sure hence my question. I had to replace 1 tire that was new but flat in the front, probably this is the same issue. If everything else checks out...

Will fo that next. Thanks.

Yes, I am going to pull out the tire and also check the hub and spindle. I also see the tire wiggle a bit while on the way. On the temperature issue, I hope is the gauge as I don't smell over heating or hear crackling on the engine or anything unusual other than the gage reading.