Search results

Did you check the GP solenoid on the firewall if its bad no power to the GPs anyways and would make them all not work.

I dont think your going to keep all of the water out but there is a piece called the window wiper seal it runs along the window on the outside in the window opening (where your elbow rests while driving) it should be replaced when doing the channels. I replaced all of mine its a real PITA to get...

Window tracks are an easy install they are felt lined steel channels front one has a hook on the bottom that slides over a slot in the door frame top has a rivet holding it you can see it at the top once the door is opened. The back or latch side has the hook on top and a screw at the base...

A few more parts waiting to be installed.

Got the floor herculined and the springer bases cut down and angle welded in to bolt in the new freightliner highbacks a friend gave me. The seat bases will get a coat of OD if the damp cold weather ever finally goes away. Im planning on useing springer bases for both seats likeI did in my 813...

I just did some measuring the wheel well on the 1101 will end up pretty much at the same spot it ends up useing a 105 the wheel well being set further back on the 1101. I measured the deuce springs and the hangar on the rear will just have enough frame to fit if I cut the frame flush to install...

Anybody consider an 1101 bed for a bobbed deuce? I am bobbing a deuce I just bought and am weighing my options for the bed I have an 1101 sitting here in the drive and was measuring it up for an option. The trailer is a completely rivited together unit making fabrication and modification pretty...

Check with Roger down in KY I think farmall unloaded a bunch of NOS fenders for the older five tons on him.

If you bought that truck in elgin I missed it by hours I called Richard and he he just sold it that truck sat for two years a mile from my house and never knew it was there. He said it was an old pole setting rig the forest preserve used to have it in kane county they took the drilling rig off...

No attitude intended I was just reading two locked threads that were closed for ads not posted in the classifieds just wondering why this wasnt given the same outcome.

Where is porky isnt there advertising on open forum here.

OK

I have a set of cloth suburban seats here I would sell they need to be cleaned but they have no rips or holes in them. I get them from a friends junkyard when a decent set comes in they call me and I go and remove them. These will bolt right up to the stock 1009 seat bases without modification...

Everything went fine no pics yet I have the fuel tank off the truck Im going to clean it out tomorrow at work.

Its here sitting in the driveway made the 450 mile drive home fine not even a hiccup. Changed the oil out there ran it until well after dark 8 PM found a motel and stayed for the night went out in the morning 15 degree temps it fired right up no ether needed and drove the rest of the way home.

John Im not out of the woods yet we still have a four hundred mile drive home for the old girl to make.

Hey Tony got the truck running no problems it has a whistler no rust and runs and drives fine. I let it run a couple hours aired up all the tires changed out the fuel filters and got the shut off lubed up and working as it should and drove it out of the back forty into the front drive and parked...

He did mention a person had called him but he was unsure if the deal was going to happen he called me an hour later to say it was mine if I still wanted it I had assumed the other deal fell through. This is how FREE deals go Im old enough to realize if it seems to good to be true it usually is...

I offered him some cash for it after all the driving back and forth and trying to line up storage or whatever else I need its far from free but I knew that from the beginning.

I think I might have bought a hard top from him years ago his place is just outside fort leonard wood.