• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. A

    Look what I just won on GL only 50 hours on it

    RE: gl You can run the electric heaters with it.. you will need a helper though cuz it weighs about 300 lbs and at 3600 rpm it will keep the neighbors awake but good...The helper is used also to fetch gasoline cuz they are thirsty brutes...ACE
  2. A

    Diagnostic Plug

    RE: plug frank;s surplus had some new ones on Epay... Several hundred dollars with all the adaptors etc usually... ACE
  3. A

    1952 M211 Headlights

    Go to a truckstop store and get a couple of civilian 24 volt headlights from a big truck... go to Napa get two headlight pigtails... put your choice of connectors on the pigtails and you have now solved the headlamp problem... Many dealers have the headlights with wires and bullet connectors...
  4. A

    New 5-ton Brush Fire Truck Arrived

    The Marine Corps 5 ton body off the M813A1 has drop sides and is aluminum I believe... Have your State Screener check em out... ACE
  5. A

    Washing CARC paint??

    Mother Nature's acid rain washes mine... sometimes it is white rain like yesterday....12 inches of it....ACE
  6. A

    m151a1 troubleshooting questions

    I have a new -10 operator's manual for $10 if ya want it.. ACE
  7. A

    M 715 rebuilt carb, now idles rough and then dies

    that little Holley should not be a problem to rebuild... sounds like a vacuum leak or a misplaced part from your rebuild...or you messed up the distributor... ACE
  8. A

    BRAKE LIGHT

    Correctimondo.... There are two separate grounds in the composite lights... each bolt of the two hosts some functions...ACE
  9. A

    Deuce Brakes??

    RE: Re: RE: Deuce Brakes?? Don't forget the chock blocks...
  10. A

    Rebuild my 1962 M37

    only you know how you are going to use it... for most, keeping as many of the old parts as possible is the answer...wear and tear will probably not be a concern to you cuz you are going to be kind to her... Changing axle ratios is not a concern either unless you want to go 65, and then you need...
  11. A

    N211 cooling system bolt length question

    A valid point made by BK. And the second is typical of a 50 year old vehicle.. ACE
  12. A

    Head nut wrench.

    There are two... a shortie and a longie.. Fred at Adirondack had the longies for short money ACE
  13. A

    Glow plug resistor

    Probably the glow plug card... see Jeff at Frontline for one... ACE
  14. A

    M1008 electrical question

    I had to do the tie rod ends on my M1008 at 30000... crummy GM stuff... one of them is very expensive....ACE
  15. A

    M1008 electrical question

    The glow plug relay on the engine bay firewall about top dead center will cycle off and on based on signal from the glo plug card and the heat sensor in the intake manifold..remove the small light blue wire and see if the noise stops... ACE
  16. A

    Front lifting shackles?

    I sell the safety pins... nos 4 FOR $5 RAMPARTSLLC@AOL.COM ACE
  17. A

    Wrong filters??

    I too, sell WIX filters and have them at the local East Coast shows... for low money...ACE
  18. A

    WWII International on ebay..

    Whoops, its gone... musta bin local sale... ACE
  19. A

    Inch by Inch!

    Yup, shouldn't have been more than a few ounces... or when it liquifies you will see it running down on your wheel and tire....fyi....
  20. A

    WWII International on ebay..

    thanks for the info... btw, I have one of the tanker's helmets like in your pic for sale only $150....rampartsllc@aol.com ACE
View older results
114,103members
167,071threads
2,352,232posts
3,654online users
Top