Search results

Memphis equipment made a kit to replace the gears and have a manual engagement (REB). I recently swapped out the whole transfer case due to wear issues (not REB related). The REB worked fine. I do not know if Memphis still offers this kit.

The bottom of the goat column is female spline. How did you attach a u-joint? A small section of splined shaft?

Can you post a copy of the CAD drawing?

According to the Continental literature, the water jacketed intake was designed to heat the air in cold weather.

Anecdotal information on the white tractor engine life: Today's Tractors :: View topic - White 2-155 Hercules engine ?

Maibach Tractor has the high compression pistons/sleeves. AFAIK, the tractor has the same combustion chamber design as the multifuel, just lower compression.

A rod knowck will also get louder as the engine gets warmer. My truck also makes a knock when cold; I have suspected that it was a loose valve.

Even a full rear exhaust on my bobbed deuce, there was a ton of whistle noise from under the hood with the C turbo. You will be miles ahead in noise reduction if you get the D turbo.

So, was it Continental, White, then Hercules? I have what appears to be a Hercules manuf in the late 60s.

http://www.woodwardsteering.eu/PDF/Power-Steering-System-Components.pdf

Not terribly expensive: Sweet Mfg. Power Steering Servos - Speedway Motors, America's Oldest Speed Shop

You misinterpreted my post. My intent was to state that there seems to be a common belief that the law requires a mechanical connection and yet an OEM has produced a vehicle wihtout said connection. This implies that these law(s) no longer exist.

I am 99% sure that it WAS illegal in SD. However, I can't find the old motor vehicle code book. It appears like the consensus is that there must be a mechanical connection between the steering wheel and the front axle. However, Chevy had the quadrasteer in their pickups and I can't imagine...

Just curious, were you using M35 Tom's head gaskets or old stock?

How about here: http://www.powermaxparts.com/DEMO/copyOfX-HERC-478-A.html

To add a little detail: There are four general types of bond mechanisms : ionic (NaCl), covalent (metals), mechanical (bolt and nut, velcro), and van der waal (scotch tape, gecko). It is generally accepted that paint adheres via a combination of van der waal and mechanical bonds. Sandblasting...

You'll spend more to have them recentered than it will cost to get the right wheel. Rims are $50-100 each in my area. Recentering is ~$300 each. Used tires are easy to find at truck shops.

Welcome to the site.

Will this require that the big end be resized or is this a remove and replace?

I was never able to do it runing Firefox; Explorer works fine.