Search results

Thanks Welder1. I've wanted to get the boots and do this too, but I also didn't think they'd go over the fittings.

Comfy looking seats.

Over a couple week span, I removed it's front nervous system (AKA front harness). Probably at least 20 hours in this task. For those that have never undertook this, it's not for the faint of heart. Every clamp bolt was rusted solid, or the threads were stripped out, and the nut would just spin...

http://www.steelsoldiers.com/upload/M35/TM9-2910-226-34.pdf This one?

90100A is the LDT pump head. 90101A is the LDS pump head. I don't think anyone has dissected one of each, and did a direct comparison.

The M35A3 used 12.5" x 20" tires, which I think are 42" tall. That only adds 1" additional trailer height over A 9.00" x 20", which is 40". I don't know the availability of that tire size, though.

Welcome from N. Florida.

Big truck mud flaps. the ones with the fibers in them. Or buy them. http://www.bigmikesmotorpool.com/products/radiator-mount-anti-vibration-pads-7529294

Welome from another North Floridian.

Try this. http://www.steelsoldiers.com/showthread.php?74240-Brake-light-switch-replacement

I do the same, but I put the magnets in heavy duty zip lock bags. When done, hold over wherever you want to put the chips, reach in the bag, pull out the magnet, and all the chips just fall off. I hate trying to get all the fine steel off. Especially off of rare earth magnets.

I would say Baden-Württemberg(BW), a state, so to speak, in Germany.

Hey rustystud, You don't think Red Oak from Home Depot will hold up? http://www.steelsoldiers.com/showthread.php?67703-What-did-you-do-to-your-deuce-this-week/page90 Post #3565

Forgiven. But if we're talkin about the M35A2 in your sig line, you should have 24+ VDC @ the starter pushbutton, not 13 VDC.

I had a similar problem, OHM'd the pushbutton, it checked good. Spent another fours troubleshooting, and came back to the push button. It OHM checked good again with a different VOM when the button was pushed, so I took the two wires off, touched them together, started right up. Put the wires...

Great Idea. And thanks for having the fore thought to post the link for the springs.

Spelling helps the next persons search. You could pull the inspection cover, and just have a look around in there to be safe. Can't think of what kind of oil that could be.

So, you've called it both a "folding plug", In the thread title, and then a "forming plug" in thread text. I'm assuming you mean the "Fording Plug"? It would probaly be a good idea to to use some Brakecleen, and spray it out a little just so it just does'nt keep dripping. Gear oil has a very...

Could'nt make it load right.

75M35A2, Not to try and make matters worse, but just take this as some constructive criticism. Trying a little harder for good punction always goes a long way. You know, commas, capitalization, periods, etc. It's way easier to read a post when there's good punctuation. We know nobody's...