Search results

Thanks, I checked and corrected the settings. If this does not work I'll post again. Bill :-D

Still trying to figure this out. It would really help if I could receive a post when there are postings on the threads I am subscribed to?? Thanks, Bill Michigan :?:

I used a hand band saw by Porter Cable to cut off the frame. Made a real nice clean cut. Harbor freight sells a cheap version that uses the same blades. They sell the quality blades for their cheap saw. An angle grinder with flap discs was great for removing the rust from the frame. A torch...

Hi, I have found that I no longer receive notification when someone posts in a thread I am subscribed to? I have checked to confirm that I am really subscribed to the threads. I also checked that my email address is correct in my personal information. Can someone help. Thanks, Bill...

I did gain some height with the 5 ton spring setup. I'll get a measurement frame to floor tonight. anyone know the original frame to floor height for an m35? The notch I mentioned cutting in the rear end of the frame rail will be a consequence of, when the tailgate is folded down, the rear of...

I know it justin, But I already have these. Did you see how I configured the rear crossmember and hitch? I measured it all out so it will all just clear and the tailgate will hinge strait down. I'll still have to cut a couple of notches in the end of the frame rails when the bed is in place for...

I am working on bobbing a deuce using the front spring set from a 5 ton truck. I currently have the bed off and it is the perfec time to get into the rear Differential. I purchased two detroit lockers from Reider Racing several years ago. I had originally planned to install them in the rear...

Bjorn, Yep, just get rid of that "e" by the @ sign and my email address will be correct. Thanks, Bill

It was several years ago, but I think it was $150 to $500 per cylinder. This was cheaper for me as all my cylinders had to be shipped from Germany. The snow has melted off, but the weather is still cold and miserable. I am trying to clean out my garage and have a garage sale so I can get back...

Hi Justin, I rebuilt a knuckleboom crane for my truck and it needed all cylinders rebuilt. I found it cheaper to buy new, custom made ones from www.baileynet.com They can make any cylinder you need. Bill Michigan

Here are my photos from junk to jewel. Only took 7 years! Bill Michigan

The foam supplied in the arctic kit looks nice and helps a lot. Bill

How about a kit? Ever think of making a kit? I would sure like to put one on my truck. Bill Michigan

I have been working on my deuce project and am looking for some components. I was considering trying to install the 5 ton truck power steering components. Anyone done that? How much fabricating/cutting, etc is involved? Anyone in Michigan have a spare deuce winch & associated parts lying...

Thom, I am currently working on bobbing a deuce and am planning to use a set of 5 ton front springs for the rear. I had the same thought that it would provide some extra payload capacity. The only problem I see is that a duece rear axle is 3 1/2 inches square and a 5 ton axle 5...

Hi, I have some questions about installing a detroit locker in my deuce's axle. How hard it is? Any special tools needed? Where would i find instructions? Thanks, Bill Michigan

Maybe you should change the title to the earlier thread to one that is related to what the subject is actually about? instead of "Ummmm, what??" So people can recognize and find it in the future. Bill Michigan

Hello, I have a question about what guidelines are used to determine that a thread will be deleted. I started a thread about GovLiquidation eliminating all auctions for military vehicles. This thread was titled appropriately. Soon after a member commented that this subject was being...

This new color scheme gives me a headache! The background is too dark, and the orange lettering too glaring. Is there any way to change it on my computer? Bill

What and who are "Marsh Wheels" I am looking for my best wheel and tire options. Any contact info would be great! Thanks, Bill Michigan