Search results

The Colorado State Forest Service has 150 M35's and M715's located throughout the State.

The napa part number for the master cylinder is 2842. It is kinda expensive at around $200. Hope this helps.

Will these replace the duce someday soon??

Those are nice but I want one of these. MTVR or MTT! Is the military using these? http://www.oshkoshtruck.com/defense/products%7Emtvr%7Ehome.cfm

I ordered a master cylinder from Napa for a 80's International Truck and it was identical to what the duce uses. It was green and even said 2 1/2 Ton on it! I will get a part number later this week.

Post this on TheDieselPlace.com they have a tranny section

I went ahead and siliconed it, thanks for the reply. If it doesnt seal then I will order a gasket.

I am looking for a steering gearbox gasket. I would like to try and get a gakset from Napa or Carquest before I call Saturn or Memphis. Does anyone know who makes this gearbox or know a part number? Thanks

I covert our trucks to a 12v manual glow plug system that uses a momentary switch and comes off one battery. It has worked great for 5+ years with no problems. Some folks say that coming off one battery is bad but glow plugs stay on for very little time. I use AC Delco 60g glow plugs from...

From your pictures it looks like your inner clamp screw is in the WRONG location. The screw needs to be at the top of the knuckle assemby. WHy? Because when you turn the steering wheel the knuckle moves and there is not enough clearance between the rotating assemby. I found this out the hard...

Also, remember to position the inner bolt clamp straight up, or when you turn, the bolt will catch on the steering kuckle and rip everyting apart. I found out the hard way...

I installed all new brake shoes on my duce and the right middle dual shoes are rubbing with the ecentrics all the way adjusted in. It seems like the drum or shoes are bell shaped. I adjusted the lower ecentrics with no help. Any great ideas to fix this? After driving the brake shoes smoke...

No, I have NSN 2920-01-031-902

I found a MIL Trailer, looks like it held a Large Duetz compressor, it has duel axles and looks heavy duty. I was thinking i could use this to haul a car or some stuff...? Any ideas on how these trailers perform?

Here in CO we do VIN verifications when someone from out of state needs to register there vehicle, motorcylcle or trailer. It is a simple form that checks the VIN and what type of vehicle it is, I used to do these when I performed emission tests. I wonder if this VIN Veri. might work...?

I made a big pickle fork and use a lot of heat. Dont use too much heat that you melt the bushing right out! heat hammer hammer hammer

great thanks

Mike, what all did you have to convert, fabricate or do to make this swap work?

Upon replacing the clutch and trans in my M35, I noticed one of the clutch pressure plate mounting holes on the flywheel was stripped out. I was going to heli-coil this hole but noticed there is a shoulder on the pressure plate bolts. If I was to heli coil this, the bolt would not fit in the...

Lets see this crimper in action! Got any pics?