Search results

"if anyone is interested" You are just kidding, Huh? Like We All don't wanna see Your progress! Homo sapiens that save MV's is what this place is about............

Get a known good, air pressure gauge that goes over 150 PSIG. Attach it with a hose to the passenger side kick board air pressure take-off valve. Run that up to where you can see it all the time. Watch that gauge operate. It wil show the pressure increase decrease as the regulator kicks in the...

" access to a cleaner, lower mileage 6.5 for only $475 " You got that bought + stowed yet? "Has all the pumps, generator, etc., attached. Looks very clean. " Did you price out any of that?

nice shed full !

If it was done correct then it is a taper pin

How about low flying without propulsion. Glide ratio same as the space shuttle 4:1 A Cessna or a 747 is like 16:1 Make a decision.

Changing transmission and transfer case lubricating fluids is easy to do and not expensive. Read post #6 again and have at it. Do not put that drain oil into the fuel tank. see TM 9-2520-246-34-1 to see what your dealing with. Change the fluids, drive it and see what works best for your...

Just put an LED into the cab and one would always know if the switch itself is functioning with a brake pedeal press. This is just for to see if the stupid swicth is actually sending and thatswitch actually IS functioninal closed . Do you want the information / and how to do that?\ I worked...

Pretty soon We may get smell o vision and then We can find the souce. https://www.digitaltrends.com/computing/intel-loihi-neuromorphic-chip/

If all pulleys aligned properly and tension is set correct than just once use a faint mist of this stuff or similiar on it and no more slip squeal. The squeal is damage occourring and is unwanted. There is many different flavors of this stuff, many much less expensive but it works. If the belts...

a few tye wraps on it extended down to the street for slobber.

see the picture Grade ( 9 - nine) nuts.

Jackshaft nuts bolts joints 11042016.docx Have you checked the jack shaft bolts (short drive shaft between tranny and transfer case)? They have a tendency to come loose and make all sorts of strange noise at lower shaft rpm. take the passenger seat out because it's a heck of a lot...

Yes, for penetrating stuff to loosen it up. Use Kroil or the special SS mix (acetone/ ATF) that some swear by. You are correct in working any fastner back and forth to finally get it off, Not good to break stuff. ...............And give the Wife (soldier B) A BIG FAT ATTABOY and a kiss. As...

You did good and correct Bolts and nuts at that position are critical Would your like the fastener particulars?

watching this cause I will learn stuff..............

go out there with your ears and stethascope and fiqure it out Might could use soldier a and soldier b and soldier c

First time You saved it was good, second time will be even better. I did read that which you wrote I remember selling the silver coins and indian head coins for Cokes and candy

Free truck will be nice addition to the nice new barn.

Just wondering if in the coming years this thing would be adapted to run the house, It is a generator https://insideevs.com/news/394323/tesla-model-3-based-obrist-mark-ii/