Search results

Thats me

Export yourself some generic relays and rebuild it.

Did you check the trucks voltage with a meter? It could just be a stored code it may clear itself in time.

They pop up in the bay here and there. Usually the abs module is bad and it blows one of the fuses under the dash by the steering column. If you replace the fuse and it blows again the module over the back axle is shorted.

Replace the air dryer.

Once you get home put an air ride seat in. Your butt will thank you.

I dont see why not they print plastic. When I do wheel o rings I use the thick ones and i use rtv in the ring channel and around the bolt area. Done like that they shouldnt leak.

I bet you could set up a 3d printer to make gaskets

I have a 22k 3 phase gen I use 2 legs for single phase it was kind of already set up like that by the military anyways. You dont want too much of an unbalanced load though. I have mine set up with 2 30amp plugs I have breakout boxes for them. 120v x 30a is 3600 watts and thats the max I would...

I have surepower and vanner 100 amp ones

You can get some fittings and temporarily bypass the air dryer.

Somewhere there is a blockage in your air system you need to troubleshoot. Start taking lines off in the air supply path find the problem. If you need a part there are people in Ohio.

Take off the air dryer output air line see if you have good air flow. If good there follow the hose to the first tank there is a check valve there.

I wonder if one of your check valves is stuck or the ppv is somehow stuck

Do you windshield wipers work?

I would just replace it. Where are you? Maybe someone close by with a new one.

Are you sure its not the expello valve on the bottom center of the air dryer getting stuck? You can stick your finger in there and push it back up.

I just swapped out a bad air dryer the valve is good though. If I can get it off in one piece you can have it.

Check the bottom left lever move it upward a notch or two

Was it the small safety relief on the side of the air dryer? Had one of those go bad on me once. Good to have it there though. If your ppv were to fail and you didnt have that safety air pressure would just build until something burst.