Search results

(1) Speed of the M37 | SteelSoldiers Older thread I was reading. Also looking through the shop manual adjusting the governor is not a whole lot of fun if you need special tools.

Governor set too low? Looking good though. I wish I had a Tac hooked up as my motor seems to be screaming at 45 mph. I have pushed it farther a couple of times but now I drive at 35 / 40.

Some problems came up and sorry to all that wanted to get so me goodies from me. Got most of the problems figured out and sorry again I can not make it to Denton this year.

Yea been to more then my share of closing and always go early. With ADHD I can not sit for an hour without falling asleep. Looks like now they are saying closing is May first so happy me. No spare lids sorry.

Might be a problem. Selling some property and they want to close on Friday. I am asking if I can sign a couple of days early like Wed. so I can still make it up there. Up date now they say May first for closing. Nice.

I might have one packed up in the trailer so come see me and it's free.

The power of prayer must be working so thanks if you said one she got the raise plus more.

Do not know if that's his problem. I do know I have to keep all the cans caged on my 1088 or they will lock up / rust up tight. Have to break out the BFH to roll.

Single or double chain? I do not need them just asking.

I have been known for working , paying or bartering MV parts for food. I do not eat a lot as it ruins my girlish figure.

OK while looking for a 3/4'' tow bar pin for a member I found a surprise. Two 1 x 3/4 feet with correct non roll 3/4'' pins but no 1 inch pins. I will bring them to Denton and how bout $80.00 for the pair. I have been known to barter or work for the correct brownies.

Yea I to have thought about a bigger engine replacement and the work replacing the axles and front spring hangers. Also thought about just the body switch to a newer frame big engine with four wheel drive. The guy that did the resto did such a good job thinking about it I hate to do anything but...

Trying to help a member that might have lost the governor linkage to fuel control unit assembly clip. I hope he finds his but has anyone have one they could sell him or found the correct clip with where and part number. Tanks

You think I would let my friend down. Got you covered with some other rubber chocks if you want them. Still as planned Sea you guys there.

Heavy duty wheel chocks. Buy the rusty one for $20.00 bucks one get the other two nicer ones for free. M37 fording exhaust pipe $100.00

Do not know if you want to work with it but West systems epoxy has different fillers to be added to it. Range from easy to sand to very hard. Just a thought. Epoxy Filler Selection Guide for Marine Grade WEST SYSTEM Epoxy

PM sent

Center nut no.

Jack shaft. Transmission in 5th transfer case neutral looking at the back side of the motor go counter clockwise. NY tom you type just a second faster than me. As with anything I loosen then retighten if it needs to be tighten up. I would replace the line before I cut the stock line and used new...

3 oclock in the morning and you are thinking about a sticker. I am wondering why I am not fast asleep and this getting old thing sleeping kinda sucks. I am wondering if my internal clock is off because of the time change or just the getting old thing. Could it be closer to the grave I do not...