Search results

Thanks for the note. If you can find and point me to the correct TM I would appreciate it. I am working to get the wrenches ordered since it appears to be the correct way to go. Thanks for the help.

I have found the TM and searched them but am having trouble finding the instructions for changing the compressor belt. Can one of you help me find the TM9-2320-209-20-1, 2, 3, 4 location and page where the instructions can be found. I appreciate the help.

M35A2-AZ Where is the air compressor filter located? Do you have a drawing or can you point me to the correct mannual? I will try to clean this out and see if it shows any improvement. If not I will look for a new one.

I ran my truck the other day for about 120 miles at 60 mph and it was 95 degrees out side and 105 degrees inside the truck. The engine temp stayed about 200 for most of the trip but the last 20 min it reached 210. It appears that this caused the rear main to leak and my bet is at the same...

Is it possible for engine oil to get into the air supply of the Deuce? I have a NEW small oil leak that comes out of the flywheel housing that has only recently started. I think is from the rear main seal but is manageable at this time and considered "marking my territory" size leak...

Thank you for the insight. I have had little issue with leaking but on the last 92 degree day I drove it 120 miles on the highway and when I got home the bottom of the truck was rust proofed. Seems to be leaking little now but the temp is much cooler. I hope this works until a more handy...

Blinker fluid tank Hey thanks for the insight. Do you have a schematic of the location of the blinker fluid tank? rofl Does it require a left handed cresent wrench or a left handed screw driver?:lol: Engine oil fill right? I have gotten good help from Spedmon in the past. Do you know him?

rear main seal stop leak Where did you get the rear main seal stop leak? Where do you put the stuff into the engin oil? Looking forward to your reply.

Can the rear main seal be replaced without taking the entire engine out?

Is it possible for engin oil to get into the flywheel housing? I have what looks like motor oil coming out of the drain of the fly wheel housing. If it is possible what could be the possible causes to this?

I want to thank Kaswell at eastern surplus as he was able to hunt me down a replacement lens. Thank you to all who gave advice and places to look.

Thanks for the tip I'll keep looking let me know if you think of anything else.

Yes light bulb is on the end of the handle. This green lens covers the bulb.

Yes it is simply a treaded plastic lens that goes over the blub and it lights up when the signal blinks. Saturan Suplus is sold out as is Memphis.

I am looking for help to find a green lens for my M35A2 turn signal. NSN 6220-181-2388 Part number 20085-00 I have tried Saturn, TNJ, Memphis, eastern,OD Anyone have one or know where to find them. Thanks

Going to be starting a project to intall the artic heater I picked up into a M35A2. Does anyone have any pictures of a completed installed heater which may be helpful to see before I start. Are there any tips or tricks that you could share I would appreciate it. Thanks for the help.