• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

 

Search results

  1. J

    Home made parts...

    Knocked up these two parts over the last few days, as you can see the old fuel inlet cover was rusting away and the mount for the water can was none existent. I think my replacements are pretty good.
  2. J

    np208 atf fluid

    Can anyone confirm exactly which atf fluid goes in the transfer case. There's 4 or 5 different atf fluids, each with a different letter after it. also exactly which fluid goes in the transmission? thanks
  3. J

    Universal Joint M1009

    Hey So i ordered a new UJ from rockauto, thinking it was the right one but when it came it was too big and due to the postage costs from the UK its not worth me sending it back. Trying to be resourceful I cleaned out the cup from the old UJ that had no bearings in, greased it up and took the...
  4. J

    tranny rattle?

    tranny rattle? - updated- Hey So I took my M1009 out for a run yesterday , about 20 miles each way. After about 5 minutes I could hear a tinny rattle under neath when i come off the gas. When in cruising along at up to 50/60 you can't hear anything but as soon as you come off the gas there it...
  5. J

    idle slightly high

    Hi, I've noticed the last couple of times I've been on a run of about 30 miles or more, when I get back home the idle seems a little high. Probably only a bit over where it normally is but it hasn't done it before, any ideas? It runs great, starts great,no smoke, etc. The IP was rebuilt or...
  6. J

    m1009 vacuum hose

    Hi, can anyone tell me the internal diameter of the rubber hose that is used for the vacuum pipe. Mine is badly stretched and torn and I can't get a good measurement.It looks about 5mm, anyone verify?
  7. J

    Injector Pump Part

    Hi All On the left side of the injector pump is a plastic bolt on part that seems to have two vacuum lines going to it and the bottom of it moves as you accelerate. Can anyone tell me what this part is called as i'm trying to get one but don't seem to be able to find it listed. Thanks
  8. J

    cooling system issue? m1009

    Hi all. I recently replaced the rad, cap, t-stat, heater core, water pump and all hoses as the old rad had a hole in it and I thought I would replace everything after a few issues which seemed better after the pump was changed. my problem now is that when I've bled the air out with the cap off...
  9. J

    M1009 radiator Issues

    I recently replaced the radiator in my M1009 & all seemed to go well. I've bled the system and had it running fine with the blower nice & hot and just a little bit of water going in to the expansion tank. Then i changed the temp sender unit & installed a gauge on the dash. Since doing this i've...
  10. J

    M1009 Coolant Refill

    Hey This might be a simple thing but i haven't refilled one of these before and I want to make sure i'm doing it right. I had to replace the rad as it had a small hole in the top and wasn't pressurising the system. I replaced the rad, cap, thermostat along with the upper & lower hoses, all...
  11. J

    glow plug voltage

    Hey guys I got some new glow plugs and wanted to check the current voltage to the plugs was definitely 12v as it has a manual switch that turns the glow plugs on before you start it. You just hold it down as long as u want them on for. This was already fitted when I got the m1009, the only...
  12. J

    attention all UK members.

    Hi all Can we get a count of all members in the United Kingdom that have a cucv, might be cool to get a list going so we can share contacts for parts, tips on repairs, etc. Post what you have and where you are if that's cool with everyone? Cheers Jamie 1984 M1009
  13. J

    My First M1009

    Hey Guys Bought this in July 2012 done quite a bit of body work to it, repaint, some interior work, few bits on the engine. Runs well & starts well but i don't do a lot of miles in it. Got a new rad to go in it with new hoses, need to replace the oilpan gasket as its leaking abit on long runs...
  14. J

    Heater Under Passenegr Seat

    Hey Guys My M1009 has a Webasto heater under the passenger seat with a control box for it on the dash. The light comes on the control box but the heater doesn't do anything. It has lots of wires going to it & some kind of heater pipe coming out the side, which has a fan behind it. Can anyone...
  15. J

    Doghead Starter Relay Mod query

    Hi I'm looking to do this mod but i'm in the UK and we don't have access to the NAPA parts & if we do the shipping costs are very high. Can this be done with any other 200 amp relay such as this? If so can anyone confirm which was round the wires will go? Thanks in advance
  16. J

    CUCV Info

    Hi Guys I have an 1984 M1009. Can anyone help me find its military history if i supplied the number form the data plate? Cheers Jamie
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks