Search results

Nice looking 08. [thumbzup]

I have XL 11.00R16 on mine. So far they have been great.

You need the bracket off of the civy version, it puts the CDR at the front of the engine. The CUCV one is in the way of the tube going from the pressure side of the turbo to the intake.

I would look at everything else before replacing the sway bar or pitman arm. Unless they have been altered, I don't think you will find a solution in those two parts. 2cents

Don't adjust your screen, they are that red.

Who in the **** are they to judge you? Keep it street legal and enjoy driving what YOU want to drive. Make it look the way YOU want it to look. If someone says something to you pull the same cards out of the deck as anyone else. Be offended and file a complaint with your HOA. If something is...

Alternative Fuels - Steel Soldiers::Military Vehicles Supersite

Yep anything fun is illegal and if its not illegal its mandatory. :soapbox:

Give them about half throttle. Enjoy them just don't push them.

rofl@ just about ever response.

A lot of multimeter have a setting to check continuity. Wire up a long lead and start testing your wire runs. I've had wires just break for no reason. IF you need help with your gremlin hunting you have my number. Happy hunting.

If this is just a side track I would really hate to see when you pay attention to detail.... This is a great build.

Take it easy on your subs till they break in. They will start getting a bit louder at the same volumes as they are breaking in. 2cents

Deny-T Fuel Pin, POD injectors, gov. spring and a bigger compressor and hosing on the turbo should get you the fuel and air you need to get there. Those are the most common upgrades to the VE pump 6bt that I have seen. You can change the turbo out but the one in there has zero shaft play and...

No hurry, all though I would flush the IP and injectors with stanadyne since its going to sit till Jono gets backs. I did flush the old diesel...it was getting pretty bad. Anyways, can't wait to see the 6bt go into this build.

Just need a cummins. You know you can always call me for a photo shoot like in the last 3 pics, I can help those poor girls get on and off that truck. I would sure hate to see one of them fall. rofl

:ditto:

I've never had an issue with corrosion on a distribution block but preventative maintenance of any kind is never a bad idea. A good dielectric couldn't hurt being these don't really have insulation and see quit a bit more condensation inside.

rofl

I just drilled and used a grommet. I didn't care to go into any factory stuff if I didn't have to. It tears and pulls the grommet out. With how and where the speakers are getting installed I would use these. Bass Stopper 1.2 kHz/600 Hz I would try and take most of the bottom end out of them for...